’03 Rav4_U (L/O 0208)
Checking the radiator and
condenser
Checking brake fluid
If any of the above parts are extremely
dirty or you are not sure of their condi-
tion, take your vehicle to Toyota dealer.
Remove and replace the reservoir cap by
hand. Fill the brake fluid to the dotted
line. This brings the fluid to the correct
level when you put the cap back on.
CAUTION
Use only newly opened brake fluid. Once
opened, brake fluid absorbs moisture from
the air, and excess moisture can cause a
dangerous loss of braking.
To prevent burning yourself, be care-
ful not to touch the radiator or con-
denser when the engine is hot.
CAUTION
NOTICE
Take care when filling the reservoir
because brake fluid can harm your
eyes and damage painted surfaces. If
fluid gets in your eyes, flush your
eyes with clean water immediately. If
you still feel uncomfortable with your
eyes, go to the doctor.
To prevent damage to the radiator
and condenser, do not perform the
work by yourself.
To check the fluid level, simply look at
the see−through reservoir. The level
should be between the “MAX” and
“MIN” lines on the reservoir.
It is normal for the brake fluid level to go
down slightly as the brake pads wear. So
be sure to keep the reservoir filled.
NOTICE
If the reservoir needs frequent refilling, it
may indicate a serious mechanical prob-
lem.
If you spill some of the fluid, be sure
to wash it off with water to prevent
it from damaging the parts or paint.
If the level is low, add SAE J1703 or
FMVSS No.116 DOT 3 brake fluid to the
brake reservoir.
2003 RAV4 from Aug. ’02 Prod. (OM42517U)
230
English 
