In case of an emergency -> If you have a flat tire for Your Toyota Rav4 SUV Third Generation (2006-2012)

’07 Rav4_U (L/O 0701)  
If you have a flat tire—  
1. Reduce your speed gradually,  
keeping a straight line. Move cau-  
tiously off the road to a safe place  
well away from the traffic. Avoid  
stopping on the center divider of  
a highway. Park on a level spot  
with firm ground.  
2. Stop the engine and turn on your  
emergency flashers.  
3. Firmly set the parking brake and  
put the transmission in “P”.  
CAUTION  
D Make sure to set the jack prop-  
erly in the jack point. Raising  
the vehicle with jack improper-  
ly positioned will damage the  
vehicle or may allow the ve-  
hicle to fall off the jack and  
cause personal injury.  
When jacking, be sure to observe  
the following to reduce the possi-  
bility of death or serious injury:  
D Follow jacking instructions.  
D Do not put any part of your  
body under the vehicle sup-  
ported by the jack. Otherwise,  
personal injury may occur.  
D Never get under the vehicle  
when the vehicle is supported  
by the jack alone.  
D Use the jack only for lifting  
your vehicle during wheel  
changing.  
D Do not start or run the engine  
while your vehicle is supported  
by the jack.  
4. Have everyone get out of the ve-  
hicle on the side away from traffic.  
5. Read the following instructions  
thoroughly.  
D Do not raise the vehicle with  
D Stop the vehicle on a level firm  
ground, firmly set the parking  
brake and put the transmission  
in “P”. Block the wheel diago-  
nally opposite to the one being  
changed if necessary.  
someone in the vehicle.  
D When raising the vehicle, do  
not place any objects on top  
of or underneath the jack.  
D Raise the vehicle only high  
enough to remove and change  
the tire.  
355  
2007 RAV4 from Dec. ’06 Prod. (OM42662U)  
’07 Rav4_U (L/O 0701)  
—Required tools and spare  
tire  
1. Get the required tools and  
spare tire on the back door.  
NOTICE  
Do not continue driving with a  
deflated tire. Driving even a  
short distance can damage a  
tire and wheel beyond repair.  
To prepare yourself for an emergency,  
you should familiarize yourself with  
the use of the jack, each of the tools  
and their storage locations.  
Tool bag  
Jack  
356  
2007 RAV4 from Dec. ’06 Prod. (OM42662U)  
’07 Rav4_U (L/O 0701)  
To remove the jack, turn the jack joint  
by hand.  
To remove: Turn the joint in direction  
1 until the jack is free.  
To remove the spare cover:  
2. Close the back door. Remove the  
spare tire cover.  
1. Open the back door. Unhook the  
latch handle which on the bottom  
of the spare tire cover.  
To store: Turn the joint in direction 2  
until the jack is firmly secured to pre-  
vent it flying forward during a collision  
or sudden braking.  
To prevent theft, the latch handle can  
be released only when the back door  
is opened.  
357  
2007 RAV4 from Dec. ’06 Prod. (OM42662U)  
’07 Rav4_U (L/O 0701)  
—Blocking the wheel  
—Removing wheel ornament  
Type A  
To remove the spare tire, turn the  
holddown nuts counterclockwise  
with the wheel nut wrench and re-  
move them.  
2. Block the wheel diagonally op-  
posite the flat tire to keep the  
vehicle from rolling when it is  
jacked up.  
When stowing the spare tire, put it in  
place and secure it to prevent it from  
flying forward during a collision or  
sudden braking.  
When blocking the wheel, place a  
wheel block in front of one of the front  
wheels or behind one of the rear  
wheels.  
Type B  
358  
2007 RAV4 from Dec. ’06 Prod. (OM42662U)  
’07 Rav4_U (L/O 0701)  
—Loosening wheel nuts  
3. Remove the wheel ornament.  
CAUTION  
Pry off the wheel ornament, using the  
beveled end of the wheel nut wrench  
as shown.  
Never use oil or grease on the  
bolts or nuts. The nuts may loose  
and the wheels may fall off,  
which could cause a serious ac-  
cident.  
CAUTION  
Do not try to pull off the orna-  
ment by hand. Take due care in  
handling the ornament to avoid  
unexpected personal injury.  
4. Loosen all the wheel nuts.  
Always loosen the wheel nuts before  
raising the vehicle.  
Turn the wheel nuts counterclockwise  
to loosen. To get maximum leverage,  
fit the wrench to the nut so that the  
handle is on the right side, as shown  
above. Grab the wrench near the end  
of the handle and pull up on the han-  
dle. Be careful that the wrench does  
not slip off the nut.  
Do not remove the nuts yet—just un-  
screw them about onehalf turn.  
359  
2007 RAV4 from Dec. ’06 Prod. (OM42662U)  
’07 Rav4_U (L/O 0701)  
—Positioning the jack  
—Raising your vehicle  
CAUTION  
Never get under the vehicle when  
the vehicle is supported by the  
jack alone.  
5. Position the jack at the correct  
jack point as shown.  
6. After making sure that no one  
is in the vehicle, raise it high  
enough so that the spare tire  
can be installed.  
Make sure the jack is positioned on  
a level and solid place.  
Remember you will need more ground  
clearance when putting on the spare  
tire than when removing the flat tire.  
To raise the vehicle, insert the jack  
handle into the jack (it is a loose fit)  
and turn it clockwise. As the jack  
touches the vehicle and begins to lift,  
doublecheck that it is properly posi-  
tioned.  
360  
2007 RAV4 from Dec. ’06 Prod. (OM42662U)  
’07 Rav4_U (L/O 0701)  
—Changing wheels  
—Reinstalling wheel nuts  
7. Remove the wheel nuts and  
change tires.  
Before putting on wheels, remove any  
corrosion on the mounting surfaces  
with a wire brush or such. Installation  
of wheels without good metaltomet-  
al contact at the mounting surface can  
cause wheel nuts to loosen and  
eventually cause a wheel to come off  
while driving.  
8. Reinstall all the wheel nuts fin-  
ger tight.  
Lift the flat tire straight off and put it  
aside.  
Reinstall the wheel nuts (tapered end  
inward) and tighten them as much as  
you can by hand. Press back on the  
tire back and see if you can tighten  
them more.  
Roll the spare wheel into position and  
align the holes in the wheel with the  
bolts. Then lift up the wheel and get  
at least the top bolt started through  
its hole. Wiggle the tire and press it  
back over the other bolts.  
361  
2007 RAV4 from Dec. ’06 Prod. (OM42662U)  
’07 Rav4_U (L/O 0701)  
—Lowering your vehicle  
CAUTION  
CAUTION  
Never use oil or grease on the  
bolts or nuts. Doing so may lead  
to overtightening the nuts and  
damaging the bolts. The nuts  
may loose and the wheels may  
fall off, which could cause a seri-  
ous accident. If there is oil or  
grease on any bolt or nut, clean  
it.  
D When lowering the vehicle,  
make sure all portions of your  
body and all other persons  
around will not be injured as  
the vehicle is lowered to the  
ground.  
D Have the wheel nuts tightened  
with torque wrench to 103 N·m  
(10.5 kgf·m, 76 ft·lbf), as soon  
as possible after changing  
wheels. Otherwise, the nuts  
may loosen and the wheels  
may fall off, which could cause  
a serious accident.  
9. Lower the vehicle completely  
and tighten the wheel nuts.  
Turn the jack handle counterclock-  
wise to lower the vehicle.  
Use only the wheel nut wrench and  
turn it clockwise to tighten the nuts.  
Do not use other tools or any addition-  
al leverage other than your hands,  
such as a hammer, pipe or your foot.  
Make sure the wrench is securely en-  
gaged over the nut.  
Tighten each nut a little at a time in  
the order shown. Repeat the process  
until all the nuts are tight.  
362  
2007 RAV4 from Dec. ’06 Prod. (OM42662U)  
’07 Rav4_U (L/O 0701)  
—Stowing flat tire  
10.Install the flat tire and spare tire  
cover on the back door.  
CAUTION  
Make sure that the rubber rings  
are not installed to the wheel  
nuts for aluminum wheel. Other-  
wise, the nuts may become loose  
and the wheel may fall off, which  
may cause a serious accident.  
CAUTION  
Make sure flat tire and spare tire  
cover are securely in place in  
their storage location to reduce  
the possibility of personal injury  
during a collision or sudden  
braking.  
After repairing the flat tire, be sure  
to reinstall the rubber rings to the  
wheel nuts before stowing the spare  
tire. If the steel wheel is stowed with-  
out reinstalling the rubber rings to the  
wheel nuts, the spare tire carrier may  
produce abnormal noise when the ve-  
hicle is driven.  
On vehicles with aluminum wheels  
and a steel wheel for the spare, re-  
move the rubber rings from the wheel  
nuts of the spare tire carrier before  
stowing a flat tire. Be careful not to  
lose the rubber rings after removing  
them.  
363  
2007 RAV4 from Dec. ’06 Prod. (OM42662U)  
’07 Rav4_U (L/O 0701)  
Guides  
On some models—Before stowing the  
flat tire, remove the center wheel or-  
nament by pushing from the reverse  
side.  
Be careful not to lose the wheel orna-  
ment.  
To install the spare tire cover:  
2. Attach the cover by hooking the  
2 inner protrusions.  
1. Insert the hooks under the guides  
to the upper slots and lower the  
cover.  
Check that the cover is securely at-  
tached.  
364  
2007 RAV4 from Dec. ’06 Prod. (OM42662U)  
’07 Rav4_U (L/O 0701)  
—Reinstalling wheel ornament  
Type A  
Type C  
3. Open the back door. Lock the  
latch handle which is on the bot-  
tom of the cover.  
11.Reinstall the wheel ornament.  
Type A and B—  
4. Close the back door.  
1. Put the wheel ornament into posi-  
tion.  
Check that the cover is securely in  
place.  
Type A only: Align the cutout of  
the wheel ornament with the valve  
stem as shown.  
2. Then firmly tap the outer edge of  
the wheel cap with the side or heel  
of your hand to snap into place.  
Type B  
365  
2007 RAV4 from Dec. ’06 Prod. (OM42662U)  
’07 Rav4_U (L/O 0701)  
—After changing wheels  
Type C—  
Push the wheel ornament into the  
center hole.  
With a spare tire of different wheel  
type from the installed tires, the wheel  
ornament can not be installed into the  
spare tire. After repairing the flat tire,  
reinstall the wheel ornament.  
12.Check the air pressure of the re-  
placed tire.  
CAUTION  
Adjust the air pressure to the specifi-  
cation designated on page 427 in  
Section 8. If the pressure is lower,  
drive slowly to the nearest service  
station and fill to the correct pressure.  
Do not forget to reinstall the tire infla-  
tion valve cap as dirt and moisture  
could get into the valve core and  
possibly cause air leakage. If the cap  
is missing, have a new one put on as  
soon as possible.  
Before driving, make sure all the  
tools and jack are securely in  
place in their storage location to  
reduce the possibility of person-  
al injury during a collision or  
sudden braking.  
CAUTION  
D Take due care in handling the  
ornament to avoid unexpected  
personal injury.  
13.Restow all the tools and jack se-  
curely.  
D Do not attach a heavily dam-  
aged plastic wheel ornament.  
It may fly off the wheel and  
cause accidents while the ve-  
hicle is moving.  
As soon after changing wheels as  
possible, tighten the wheel nuts to the  
torque specified on page 427 in Sec-  
tion 8 with a torque wrench. Have a  
technician repair the flat tire.  
366  
2007 RAV4 from Dec. ’06 Prod. (OM42662U)