’07 Rav4_U (L/O 0701)
Emergency flashers
High−Low beams—For high beams, turn
the headlights on and push the lever away
from you (position 1). Pull the lever to-
ward you (position 2) for low beams.
TURN SIGNALS
To turn on the emergency flashers,
push the switch.
To signal a turn, push the headlight/
turn signal lever up or down to position
1.
All the turn signal lights will flash. To turn
them off, push the switch once again.
The headlight high beam indicator light
(blue light) on the instrument panel will
tell you that the high beams are on.
The key must be in the “ON” position.
Turn on the emergency flashers to warn
other drivers if your vehicle must be
stopped where it might be a traffic hazard.
The lever automatically returns after you
make a turn, but you may have to return
it by hand after you change lanes.
Flashing the high beam headlights
(position 3)—Pull the lever all the way
back. The high beam headlights turn off
when you release the lever.
Always pull as far off the road as pos-
sible.
To signal a lane change, move the lever
up or down to the pressure point (position
2) and hold it.
The turn signal light switch will not work
when the emergency flashers are operat-
ing.
You can flash the high beam headlights
with the knob turned to “OFF”.
If the turn signal indicator lights (green
lights) on the instrument panel flash faster
than normal, a front or rear turn signal
bulb is burned out. See “Replacing light
bulbs” on page 416 in Section 7−3.
115
2007 RAV4 from Dec. ’06 Prod. (OM42662U)
English 