Get Lighting -> Exterior lighting Guide for Vauxhall Combo Van Fifth Generation (2018-2026)

Lighting

121

Entry lighting ............................ 128

Exit lighting .............................. 128

Vehicle locator lighting ............ 129

Peripheral lighting .................... 129

Battery discharge protection .... 129

Exterior lighting

Light switch

Lighting

Exterior lighting .......................... 121

Light switch .............................. 121

Automatic light control ............. 122

High beam ............................... 122

High beam assist ..................... 122

Headlight flash ......................... 123

Headlight range adjustment .... 124

Headlights when driving

abroad .................................... 124

Daytime running lights ............. 124

Hazard warning flashers .......... 124

Turn lights ................................ 125

Front fog lights ......................... 125

Rear fog light ........................... 125

Parking lights ........................... 126

Reversing lights ....................... 126

Misted light covers ................... 126

Interior lighting ........................... 126

Instrument panel illumination

control ..................................... 126

Interior lights ............................ 127

Reading lights .......................... 127

Sunvisor lights ......................... 127

Turn light switch:

AUTO : automatic light control

switches automatically

between daytime running

light and headlight

: sidelights

8

9

: headlights

When switching on the ignition,

automatic light control is active.

Control indicator 8 3 106.

Lighting features ........................ 128

Centre console lighting ............ 128

122

Lighting

Daytime running light 3 124.

Push lever to switch from low to high

beam.

Pull lever to deactivate high beam.

Tail lights

Tail lights are illuminated together

with low/high beam and sidelights.

Automatic headlight activation

During poor lighting conditions the

headlights are switched on.

Additionally, headlights are switched

on if the windscreen wipers have

been activated for several wipes.

High beam assist

Automatic light control

This feature automatically activates

the high beam at night when vehicle

is faster than 15 mph.

It switches automatically back to low

Tunnel detection

When a tunnel is entered, headlights

are switched on immediately.

beam when:

●

A sensor detects the lights of

oncoming or preceding vehicles.

●

Driving in urban areas.

The vehicle is slower than

9 mph.

High beam

●

It is foggy or snowy.

Front or rear fog lights are

switched on.

When the automatic light control

function is switched on and the

engine is running, the system

switches between daytime running

lights and headlights automatically

depending on the external lighting

conditions and information given by

the wiper system.

If there are no restrictions detected,

the system switches back to high

beam.

Make sure the sensor is not blocked

3 10, 3 40.

Lighting

123

Activation

Indicator lever with f button

Deactivation

Headlight flash

With high beam on, pull the indicator

lever once to deactivate high beam

assist. If a headlight flash is activated

when the high beam is off, the high

beam assist will remain activated.

Pushing the indicator lever to activate

manual high beam will deactivate

high beam assist. It is also

deactivated when fog lights are

switched on.

Press f once to deactivate high

beam assist.

To activate the headlight flash, pull

lever.

Pulling lever deactivates high beam.

The latest setting of the high beam

assist is being stored and remains set

when the ignition is switched on

again.

Activate high beam assist by pressing

f once.

The green control indicator f

illuminates continuously when the

assist is activated, the blue one 7

illuminates when high beam is on.

Control indicator f 3 106.

124

Lighting

Headlight range adjustment Headlights when driving

Hazard warning flashers

abroad

Manual headlight range

When driving in countries where

adjustment

traffic drives on the opposite side of

the road, the headlights do not have

to be adjusted.

Daytime running lights

Daytime running lights increase

visibility of the vehicle during daylight.

They are switched on automatically

when the engine is running.

The system switches between

daytime running lights and low beam

automatically, depending on the

Hazard warning flashers are switched

on automatically in the following

situations:

lighting conditions.

To adapt headlight range to the

●

Braking in an emergency

(depending on the force of

deceleration).

vehicle load to prevent dazzling: turn

thumb wheel ? to required position.

0 : front seats occupied

●

In the event of an accident.

1 : all seats occupied

They are switched off the first time

you accelerate or if you press ¨.

2 : all seats occupied and load

compartment laden

3 : driver's seat occupied and load

compartment laden

Lighting

125

Activate temporary flashing by

holding the indicator lever just before

the resistance point. Turn lights will

flash until indicator lever is being

released.

To activate three flashes, tap the

indicator lever briefly without passing

the resistance point.

Light switch in position AUTO:

Turn lights

switching on front fog lights will switch

headlights on automatically.

Rear fog light

If you forget to cancel the turn lights

for more than twenty seconds, the

volume of the audible signal will

increase if the speed is

above 40 mph.

up

: right turn lights

Front fog lights

down : left turn lights

A resistance point can be felt when

moving the indicator lever.

Operated by pressing r.

Constant flashing is activated when

the indicator lever is being moved

beyond the resistance point. It is

deactivated when the steering wheel

is moved in the opposite direction or

indicator lever is manually moved

back to its neutral position.

Light switch in position AUTO:

switching on rear fog light will switch

headlights on automatically.

Light switch in position 8: rear fog

light can only be switched on with

front fog lights.

Operated by pressing >.

126

Lighting

The vehicle rear fog light is

Reversing lights

Interior lighting

Instrument panel

illumination control

deactivated when towing a trailer or a

plug is connected with the socket,

e.g. when a bicycle carrier is used.

The reversing light comes on when

the ignition is on and reverse gear is

selected.

Parking lights

Misted light covers

The inside of the light housing may

mist up briefly in poor, wet and cold

weather conditions, in heavy rain or

after washing. The mist disappears

quickly by itself; to help switch on the

headlights.

Brightness of the following lights can

be adjusted when the exterior lights

are on:

When the vehicle is parked, the

parking lights on one side can be

activated:

●

instrument panel illumination

Info Display

illuminated switches and

operation elements

1. Switch off ignition.

2. Move indicator lever all the way up

(right parking lights) or down (left

parking lights).

Confirmed by a signal and the

corresponding turn lights control

indicator.

Turn thumb wheel A and hold until

the desired brightness is obtained.

Lighting -> Exterior lighting for Your Vauxhall Combo Van Fifth Generation (2018-2026)

Related Topics

Lighting

Popular Owner Manuals

Latest Owner Manuals