2018-2026 Volvo V60 SUV WHEELS AND TIRES -> Inflate tires with the compressor included in the tire sealing system User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

WHEELS AND TIRES -> Inflate tires with the compressor included in the tire sealing system for Your Volvo V60 SUV Second Generation (2018-2026)

WHEELS AND TIRES  
16. Check the inflation pressure on the air  
pressure gauge.  
Inflate tires with the compressor  
included in the tire sealing system  
The vehicle's original tires can be inflated  
using the compressor in the tire sealing sys-  
tem.  
1. The compressor must be switched off.  
Make sure that the switch is in the 0 (Off)  
position and take out the electrical cable  
and the hose.  
WARNING  
After using the tire sealing system, the  
vehicle should not be driven farther than  
approximately 200 km (120 miles).  
If the pressure is under 1.3 bar (19 psi),  
the tire is not sufficiently sealed. The  
vehicle should not be driven. Call road-  
side assistance to have the vehicle  
towed.  
NOTE  
The compressor is an electric device. Fol-  
low local regulations for disposal.  
If the inflation pressure is higher than  
1.3 bar (19 psi), the tire must be inflated  
to the inflation pressure specified on  
the tire pressure decal on the driver's  
side door pillar (1 bar = 100 kPa =  
14.5 psi). If the inflation pressure is too  
high, use the air release valve to release  
air.  
2. Unscrew the tire's valve cap and screw  
the hose's valve connector as far as possi-  
ble onto the valve.  
Related information  
Recommended tire pressure (p. 515)  
Be sure the air release valve on the com-  
pressor's hose is completely closed.  
Tire sealing system (p. 529)  
Inflate tires with the compressor included  
in the tire sealing system (p. 533)  
3. Connect the electrical cable to the nearest  
12 V outlet and start the vehicle.  
WARNING  
Check inflation pressure regularly.  
WARNING  
Inhaling exhaust fumes could lead to seri-  
ous injury. Never leave the engine running  
in an enclosed space or a space without  
sufficient ventilation.  
Volvo recommends driving to the nearest  
authorized Volvo workshop to have the tire  
replaced/repaired. Inform the workshop that  
the tire contains sealing compound.  
The sealing compound bottle and the hose  
must be replaced after use. Volvo recom-  
mends contacting an authorized Volvo work-  
shop for replacement.  
WARNING  
Never leave children unattended in the  
vehicle while the engine is running.  
}}  
533  
WHEELS AND TIRES  
|| 4. Start the compressor by moving the  
switch to the I (On) position.  
Related information  
Determining the vehicle's  
permitted weight  
Recommended tire pressure (p. 515)  
Properly loading your vehicle will provide  
maximum return of vehicle design perform-  
ance.  
Using the tire sealing system (p. 530)  
Tire sealing system (p. 529)  
CAUTION  
Risk of overheating. The compressor  
should not be running for longer than 10  
minutes at a time.  
Weight designations  
Before loading your vehicle, familiarize your-  
self with the following terms for determining  
your vehicle's weight ratings, with or without a  
trailer, from the vehicle's Federal/Canadian  
Motor Vehicle Safety Standards (FMVSS/  
CMVSS) label, and the vehicle's tire informa-  
tion placard:  
5. Inflate the tire to the pressure specified on  
the tire pressure decal on the driver's side  
door pillar. If the inflation pressure is too  
high, use the air release valve to release  
air.  
6. Switch off the compressor. Remove the  
hose and the electrical cable.  
Curb weight  
The weight of the vehicle including a full tank  
of fuel and all standard equipment. It does not  
include passengers, cargo, or optional equip-  
ment.  
7. Screw the valve cap back onto the tire.  
NOTE  
Capacity weight  
After inflating a tire, always replace the  
valve cap to help prevent valve damage  
caused by gravel, dirt, etc.  
All weight added to the curb weight, including  
cargo and optional equipment. When towing,  
towbar weight is also part of cargo weight.  
Use plastic valve caps only. Metal caps  
could corrode and become difficult to  
remove.  
Permissible axle weight  
The maximum allowable weight that can be  
carried by a single axle (front or rear). These  
numbers are shown on the Federal/Canadian  
Motor Vehicle Safety Standards (FMVSS/  
CMVSS) label. The total load on each axle  
must never exceed its maximum permissible  
weight.  
NOTE  
The compressor is an electric device. Fol-  
low local regulations for disposal.  
534  

Related Topics

Popular Owner Manuals