116
Adjusting the headlamp beam pattern
Correct beam pattern for left
or right-hand traffic
So as not to dazzle oncoming drivers, the
headlamp beam pattern can be altered by
masking the headlamps. The quality of the
beam pattern may not be as good.
Headlamp masking
Copy the templates and transfer the pattern to a
self-adhesive, waterproof material such as
opaque tape or the like.
The mask is positioned using the dot (5) in the
headlamp lens as a reference point. The
reference measurement (X) indicates the
distance from the dot (5) to the corner of the
mask marked with an arrow.
After copying the templates located on the next
page, check the measurements so that the
reference measurements cover enough of the
beam pattern.
Halogen headlamps, LHD
variant
Copy templates 1 and 2. Check the measure-
ments to ensure they are correct. Transfer the
template to a self-adhesive, waterproof material
and cut it out.
Reference measurement:
Template 1.) (3) = 70 mm, (4) = 40 mm
Distance to dot in headlamp lens: 5=13 mm.
Template 2.) (6) = 55 mm, (7) = 40 mm
Distance to dot in headlamp lens: (8) =18 mm.
Halogen headlamps, RHD
variant
Copy templates 3 and 4. Check the
measurements to ensure they are correct.
Transfer the template to a self-adhesive,
waterproof material and cut it out.
Reference measurement:
Template 3.) (1) = 55 mm, (2) = 41 mm
Distance to dot in headlamp lens: (5) = 17 mm.
Template 4.) (6) = 70 mm, (7) = 39 mm
Distance to dot in headlamp lens: (8) = 14 mm.
A. Headlamp beam pattern for left-hand traffic
B. Right-hand traffic
Location of headlamp masks on halogen headlamps
- 1 and 2 = LHD variant, 3 and 4 = RHD variant
3501716j
English 
