Only ever use a single 12 V socket at maximum power.
115 V socket
Fig. 154 In the center console at the rear: 115 V socket (depending on the vehicle equipment).
The maximum power is 150 watts (peak power: 300 watts).
The socket is activated automatically if you plug in a connector while the engine is running. If enough power is available, you may be able to use the socket, even if
you have switched off the engine ⇒
.
Connecting an electrical device
1. To unlock the integrated child safety lock, remove the cover if necessary and insert the connector all the way into the socket.
Electricity will not start to flow through the socket until the child safety lock is unlocked.
LED display on the socket fig. 154.
Green LED comes on: The child safety lock is unlocked. The socket is ready for operation.
Green LED is blinking: The ignition is switched off but there is still
enough power to continue supplying the socket for up to ten minutes. If you pull out the connector within this period, the socket will be switched off and you will
not be able to use it again without switching the ignition back on. Red LED is blinking: There is a malfunction, e.g. cut-off due to overcurrent or excessive
temperature.
Temperature cut-off
The inverter of the 115 V socket automatically shuts down when a certain temperature is exceeded. The cut-off prevents overheating due to devices that are
connected drawing excessive power and overheating due to high ambient temperatures. You will not be able to use the 115-volt socket again until it has cooled
down.
In order to use the 115-volt socket again once it has cooled down, if a device is connected you must remove the connector connecting it to the socket and then plug
it back in again. This prevents electronic devices from inadvertently being switched back on.
DANGER
High voltage in the electrical system can cause electric shocks, serious burns, and fatal injuries.
Do not spill any liquids on the socket.
Do not insert any adapters or extension cables into the 115-volt socket. The integrated child safety lock will otherwise be switched off and the socket will
be live.
Do not insert any objects that conduct electricity, such as knitting needles, into the contacts of the 115 V socket.
NOTICE
Do not suspend excessively heavy devices or connectors (e.g. power supply units) directly from the socket.
Do not connect lamps containing a neon tube.
Only connect devices to the socket if the voltage of these devices matches the socket voltage.
The built-in overcurrent cut-off prevents electronic devices with a high inrush current from being switched on. In this case, disconnect the power supply
unit from the electronic device, wait approximately 10 seconds and then reconnect it.
220