Troubleshooting
One-touch opening and closing is not working
One-touch opening and closing is deactivated if the 12-volt vehicle battery has been disconnected or discharged
while the windows were not fully closed. The function will have to be reset.
—Switch on the ignition.
—Close all windows and doors.
—Pull and hold the button for the respective window for a few seconds.
—Then release the button.
—Pull and hold the button again.
—One-touch opening and closing is now ready for operation again.
The one-touch function can be restored for individual windows or for several windows at the same time.
The windows do not close
—Check whether there is an obstacle in the operating area.
—Attempt to close the window again within a few seconds by pulling and holding the button.
The roll-back function will be deactivated for a small section of the path of the closing window. If the closing
procedure takes longer than several seconds, the roll-back function will be reactivated.
If it is still stiff or obstructed, the window will stop and open again automatically.
—If the fault persists, go to a qualified workshop and have the system checked. Volkswagen Commercial Vehicles
recommends using a Volkswagen Commercial Vehicles dealership for this purpose.
121
English 
