● Do not connect any lamps which use neon tubes.
● Do not connect any lamps which use neon tubes.
● Only connect devices to the socket with a voltage that matches the voltage of the socket.
● With electrical devices that require a high level of current in the start phase, the built-in excess current switch
will prevent the device from being switched on. If this happens, disconnect the power supply from the
electrical equipment and reconnect after waiting approximately 10 seconds.
Unshielded devices can cause interference in the Infotainment system and vehicle
electronics.
Functional problems may occur with some devices when they are connected to the 230-volt socket with
earthing contact due to the lower power output (wattage).
Small torch
A small torch may be located in the 12-volt socket in the dash panel depending on the equipment.
1. To charge the small torch, hold the torch at the knurled wheel of the lens and insert it in the 12-volt socket.
2. To switch the small torch on and off, turn the thumb wheel on the lens.
When travelling, always leave the torch plugged into the 12-volt socket→ Small torch.
WARNING
Objects that are not secured, or are secured incorrectly, can cause serious injuries in the event of a sudden driving or
braking manoeuvre or accident. This applies particularly if objects are struck by the airbag when activated and then
flung through the vehicle interior. To reduce the risk of accidents, observe the following guidelines:
● When travelling, always leave the torch plugged into the 12-volt socket.
295
English 