Fig. 3 In the seat rail: correctly fitted net partition
Installing the net partition
1. Make sure that the sewn-in instructions label is pointing to the rear.
2. Hook the net partition up onto the left-hand side→ Fig. 2.
3. Push the rod together to hook the net partition onto the right-hand side.
4. Pull the net partition to check that it has engaged securely in the retainers in the headliner.
1
5. On the left and right sides, pull the strap down at the loop→ Fig. 3
until you can insert the T-shaped
holders into the outer seat rails.
2
6. Turn each of the T-shaped holders through 90° so that they are positioned across the seat rails→ Fig. 3
7. Make sure that the net partition is vertical and securely fitted in the seat rails.
.
Removing the net partition
1
1. Pull the loop→ Fig. 3
down to slacken the strap.
2. Turn the T-shaped holders by 90° and take them out of the seat rails.
3. Push the net partition slightly inwards on one side and lift it out of the upper retainers.
3
4. Press the release button → Fig. 1
in the joint of each cross piece and fold the cross pieces together.
5. Roll up the net partition and stow it in its plastic bag.
6. Stow the plastic bag securely in the vehicle.
WARNING
Always use the net partition carefully, observing the instructions. Risk of injury.
● The net partition is secured properly in the roof only if the T-shaped holders are securely fitted into the retainers.
● The net partition is fitted correctly in the seat rails only if the T-shaped retainers are at right-angles to the seat
rails and correctly engaged.
● The T-shaped holders must never be fitted close to the removable covers on the seat rails.
● Heavy, pointed or sharp items which are not stowed securely can cause injury in the event of sudden braking
manoeuvres or accidents. This may also happen when the net partition is fitted correctly.
● Vehicle occupants must not travel behind a fitted safety net.
456
English 
