Windows for Your Volkswagen California Van Fourth Generation (2024-2025)

Opening and closing windows  
The buttons for operating the windows are located in the driver door (→ Driver door).  
Open window: Press the button.Or: Close window: Pull the button.  
One-touch opening and closing  
One-touch opening and closing makes it possible to fully open and close the windows. The individual buttons do not  
have to be held down to do this.  
One-touch closing  
1. pull the button for the appropriate window briefly up into the second position.  
One-touch opening  
1. push the button for the appropriate window briefly down into the second position.  
Stopping the one-touch function  
1. Press or pull the button for the appropriate window again.  
Convenience opening and closing  
The windows can be opened and closed from outside the vehicle using the vehicle key when the ignition is switched  
off and the vehicle is locked:  
1. Press and hold the locking or unlocking button on the vehicle key.  
Or: hold the vehicle key in the driver door lock cylinder in either the locking or unlocking position until all  
windows are either opened or closed.  
Or: Press and hold the  
button in the vehicle key.  
2. To interrupt the function: Release the locking or unlocking button on the vehicle key.  
Or: turn the vehicle key in the opposite direction.  
The windows in the doors are closed at the same time as part of the convenience closing function.  
Set the convenience opening settings in theVehicle settings menu in the Infotainment system.  
WARNING  
Careless or unsupervised use of the electric windows can cause serious injuries.  
Open or close electric windows only when there is no-one in the operating path of the windows.  
Never leave children or people requiring assistance alone in the vehicle when the vehicle is locked. The windows  
can no longer be opened in an emergency.  
Always take all vehicle keys with you every time you leave the vehicle. The windows can still be operated using  
the buttons several minutes after the ignition has been switched off, provided that the driver door and front  
passenger door are not opened.  
NOTICE  
During sudden rain showers, water can enter the vehicle interior via open windows and cause damage to the vehicle.  
Correct operation of the controls also cannot be guaranteed.  
One-touch opening and closing and the roll-back function will not work if there is a fault in the electric  
windows. Go to a qualified workshop.  
114  
To convenience-open the windows using the key in the door lock, you must first unlock the vehicle using the  
vehicle key.  
Electric window roll-back function  
The roll-back function of the electric windows can reduce the risk of crush injuries when the windows are closed.  
If a window cannot close properly due to stiff movement or an obstacle, the window will open again immediately→  
.
1. Check to see why the window has not closed.  
2. Try to close the window again.  
If closing of the window is interrupted again, the roll-back function will be deactivated for several seconds.  
If the window still cannot be closed, it will stop at the corresponding position→  
.
The window will close without roll-back function if the button is pressed again within a few seconds→  
Please go to a suitably qualified workshop if the window still cannot be closed.  
.
WARNING  
Closing the electric windows without the roll-back function can cause serious injuries.  
Always take care when closing the electric windows.  
There must never be anyone in the movement path of the electric windows, particularly if the windows are closed  
without roll-back function.  
The roll-back function does not prevent fingers or other body parts from being pressed against the window  
frame and sustaining injury.  
The roll-back function is also active for convenience closing of the windows with the vehicle  
key.  
115  
Opening and closing the sliding window  
There are two sliding window variants:  
Press the window handle together from top to bottom(arrows on the handle).  
Pull together window handle while pulling inwards(without arrows on the handle).  
Opening the sliding window in the side panel  
1. Press together the window handle.  
Or: Press the window handle and pull it towards the inside of the vehicle.  
2. Keep the window handle in this position and open the sliding window.  
3. Make sure that the sliding window is securely engaged in one of the available positions.  
4. Release window handle.  
Closing the sliding window in the side panel  
1. Press together the window handle.  
Or: Press the window handle and pull it towards the inside of the vehicle.  
2. Keep the window handle in this position and close the sliding window.  
3. Release window handle.  
Opening and closing the sliding window in the partition  
1. Pull the window handle and open or close the sliding window.  
WARNING  
In the event of a sudden braking manoeuvre or accident, a sliding window that is not securely engaged could move  
forward and cause injuries.  
Always allow the sliding window to engage securely.  
116  
Troubleshooting  
One-touch opening and closing do not work  
If the 12-volt vehicle battery has been disconnected or discharged when the windows were not fully closed, the one-  
touch opening and closing function does not work and must be reactivated:  
1. Switch on the ignition.  
2. Close all windows and doors.  
3. Pull and hold the button for the respective window for several seconds.  
4. Release the button.  
5. Pull and hold the button again.  
The one-touch opening and closing function is now ready for operation again.  
The automatic electric window functions can be reactivated either individually or for several windows at the same  
time.  
Window cannot be closed  
1. Check whether there is an obstacle in the movement path.  
2. Try to close the window again within a few seconds by pulling and holding the button.  
The roll-back function is then deactivated for a small operating range of the closing path. The roll-back function will  
be activated again if the closing operation takes longer than a few seconds.  
The window will then stop if movement is again stiff or if there is an obstacle and opens automatically again.  
1. If the fault persists, the system should be checked by a suitably qualified workshop.  
Touch panels do not react as expected  
Moisture, dirt and grease can impede the functioning of the touch panels.  
1. Always keep touch panels clean and dry.  
117