Get Wipers and washers Guide for Volkswagen California Van Fourth Generation (2024-2025)

Operating the wiper lever

Fig. 1 On the right-hand side of the steering column:

operating the windscreen wipers.

A

B

Wipers switched off.

Interval wipe for the windscreen, or rain sensor mode. The interval wipe for the windscreen depends on the

speed of the vehicle. The wipers will wipe more frequently as the vehicle moves faster.

C

D

E

Slow wipe.

Fast wipe.

Flick wipe – wipes briefly. Push and hold the lever down for longer to wipe more quickly.

F

Wash and wipe system for cleaning the windscreen with the lever pulled. The Electronic Automatic

Temperature Control system will switch to air recirculation mode for approximately 30 seconds to prevent the

smell of the washer fluid from entering the vehicle interior.

1

Switch for wipe intervals(vehicles without rain and light sensor)or adjusting the sensitivity of the rain and

light sensor.

Fig. 2 On the right of the steering column: operating the

rear window wiper.

G

H

Interval wipe for the rear window. The wiper will wipe the window approximately every 6 seconds.

Wash and wipe system for cleaning the rear window with the lever pushed.

The wipers function only when the ignition is switched on and the bonnet or boot lid are closed.

151

WARNING

Without adequate anti-freeze, the washer fluid may freeze onto the windscreen and obscure your view.

● In winter temperatures, the windscreen washer system should only be used when adequate frost protection has

been added.

● In winter temperatures, never use the windscreen washer system before the windscreen has been heated by the

ventilation system or the windscreen heating. This could lead to the anti-freeze mixture freezing on the

windscreen and restrict the driver’s vision.

WARNING

Worn or dirty wiper blades reduce visibility and increase the risk of accidents and severe injuries.

● Always change wiper blades if they are damaged or worn and no longer clean the windscreen properly (→ Wiper

blades).

NOTICE

Incorrect handling of the wipers can lead to damage to the windscreen and wiper blades and also to the wiper

motor.

● Before starting your journey and switching on the ignition, check to make sure that the wiper lever is in its basic

position.

● Remove snow and ice from the wipers and windows.

● Always carefully loosen wiper blades that have become frozen onto the window.

● Do not switch on the wipers when the window is dry.

When switched on, the wipers will temporarily be switched to the next setting down when the vehicle is

stationary.

If the vehicle is parked during cold weather, the service position of the windscreen wipers may be helpful in

order to be able to release the wiper blades better from the windscreen (→ Wiper blades).

Wiper function

Automatic activation of the rear window wiper

The rear window wiper is switched on automatically if the windscreen wipers are switched on and reverse gear is

engaged. Automatic activation when reverse gear is engaged can be activated and deactivated in the vehicle settings

in the Infotainment system (→ Vehicle settings menu).

Heated washer jets

The heating defrosts frozen washer jets. The heating output is automatically regulated when the ignition is switched

on, depending on the ambient temperature. Only the washer jets are heated and not the hoses carrying washer fluid.

152

Rain/light sensor

Fig. 1 On the right of the steering column: wiper lever.

1

A

B

Switch for setting the sensitivity of the rain and light sensor.

The rain/light sensor is deactivated.

The rain/light sensor is active, automatic wipe when necessary.

When the rain/light sensor is activated, it automatically controls the frequency of the wiper intervals, depending on

the intensity of the rain.

Activating and deactivating the rain/light sensor

1. Push the lever to the desired position→ Fig. 1.

The automatic wipe function can be activated and deactivated in the vehicle settings in the Infotainment system

(→ Vehicle settings menu).

If the automatic wipe function is deactivated in the Infotainment system, the intervals are set at fixed levels.

Adjusting the sensitivity of the rain/light sensor

1

The sensitivity of the rain and light sensor can be adjusted manually using the switch in the wiper lever→ Fig. 1

→

.

1. For high sensitivity, adjust the switch to the right.

For low sensitivity, adjust the switch to the left.

WARNING

The rain/light sensor cannot always detect every rain shower and activate the wipers.

● If necessary, switch on the wipers manually if the water on the windscreen restricts the field of vision.

153

Troubleshooting

Washer fluid level too low

The indicator lamp lights up yellow.

Fill up the washer fluid reservoir as soon as possible (→ Washer fluid).

Fault in wipers

The indicator lamp lights up yellow.

The wipers do not wipe.

1. Switch the ignition on and off.

2. If the fault persists, go to a correspondingly qualified workshop.

Fault in rain and light sensor

The indicator lamp lights up yellow.

The wipers are not switched on automatically if it rains during rain/light sensor operation.

1. Switch the ignition on and off.

2. If the fault persists, go to a correspondingly qualified workshop.

Changes in the response of the rain and light sensor

Possible causes for faults and misinterpretationsrelating to the sensitive surface of the rain and light sensor (→ Front

view) include:

—Damaged wiper blades: a film of water or smears caused by damaged wiper blades can increase the time the

wipers are switched on, can shorten the length of the intervals between wipes or cause the wipers to run

continuously.

—Insects: insects hitting the windscreen surface can cause the wipers to be activated.

—Salt deposits: in winter, salt deposits can cause the wipers to continue to wipe the windscreen when it is almost

dry.

—Dirt: dry dust, wax, windscreen coatings(lotus effect), or detergent deposits (from an automatic car wash)can

cause the rain/light sensor to become less sensitive and react later or too slowly, or prevent it from reacting at all.

Clean the sensitive surface of the rain and light sensor at regular intervals and inspect the wiper blades for damage

(→ Vehicle care, exterior).

—Crack in the windscreen:a wash cycle will be triggered if the rain/light sensor is on when the windscreen is

impacted by a stone. The rain/light sensor will then register the reduction in sensitivity of the surfaces and adjust

accordingly. Depending on the size of the stone impact, the response of the rain/light sensor may change.

We recommend that you use an alcohol-based glass cleaner to remove wax and polish.

The wipers will try to wipe away any obstacles that are on the window. The wipers will stop moving if the

obstacle blocks their path. Remove the obstacle and switch the wipers back on again.

154

Wipers and washers for Your Volkswagen California Van Fourth Generation (2024-2025)

Popular Owner Manuals

Latest Owner Manuals