Please carry out each step only in the order specified:
Pull the cover ⇒ꢀfig. 202 forward out of the bumper in the di-
4.
rection indicated by the arrow.
5. Remove the screws (3) using the screwdriver from the vehicle
tool kit.
6.
7.
8.
Pull the light downward and then forward out of the bumper.
Release the connector ⇒ꢀfig. 203 (4) and disconnect it.
Turn the bulb (5) counterclockwise until it stops and then re-
move.
9.
Replace burned out bulbs with new bulbs that are identical to
the ones being replaced.
10.
Insert the bulb (5) in the housing and turn clockwise until it
reaches the original position.
11.
12.
Check if the bulb is installed securely.
Connect the connector (4) on the bulb so that it clicks into
place.
13.
14.
Insert the light into the bumper.
Install the screws ⇒ꢀfig. 202 (3).
Insert the cover in the bumper opposite the direction indicated
15.
16.
by the arrow ⇒ꢀfig. 202. The tab (2) must lock in place.
Install the screw (1).
The illustrations show the left fog light. The right fog light is ar-
ranged as a mirror image of the left.
English 
