2008-2017 Volkswagen Golf 4 Door Wheel trim User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Wheel trim for Your Volkswagen Golf 4 Door Sixth Generation (2008-2017)

Wheel trim  
Introduction  
In this section you’ll find information about:  
Hubcaps  
Wheel bolt caps  
Wheel covers  
More information:  
Exterior care and cleaning  
Vehicle tool kit  
Changing a wheel  
WARNING  
Unsuitable wheel covers and improper installation of wheel covers can cause accidents and  
severe injuries.  
Improperly installed wheel covers can come loose while driving and endanger other  
motorists and cyclists.  
Do not use damaged wheel covers.  
Always make sure that the flow of air for brake system cooling is not blocked or reduced  
before installing wheel covers. This applies to both factory-installed wheel covers and  
aftermarket wheel covers. Insufficient air supply may significantly increase stopping  
distance.  
NOTICE  
To help prevent damage to the vehicle, be careful when removing wheel covers and be sure to  
install them properly.  
Hubcaps  
Fig. 175 Pulling the hubcap off.  
Fig. 176 Twisting the hubcap off.  
Please first read and note the introductory information and heed the WARNINGS  
Depending on the vehicle model, the hubcaps can either be pulled off fig. 175 or removed by  
twisting fig. 176.  
Vehicles with pull-off hubcaps  
To remove Take the wire clip out of vehicle tool kit and hook it into one of the holes in the hubcap  
fig. 175.  
Pull the hubcap off in the direction of the arrow.  
To install Press the hubcap against the rim until it latches.  
Vehicles with twist-off hubcaps  
To remove Twist the hubcap to the left or right until it loosens from the wheel rim fig. 176.  
Grasp behind one of the lugs and pull the hubcap off.  
To install Push the hubcap onto the center of the rim.  
Press the hubcap against the rim until it latches.  
Wheel bolt caps  
Fig. 177 Pulling cover caps off wheel bolts.  
Please first read and note the introductory information and heed the WARNINGS  
page 369.  
on  
Take the wire clip out of the vehicle tool kit Vehicle tool kit.  
Insert the wire clip through the opening of the cover cap fig. 177 and pull off in the direction of  
the arrow.  
The caps are designed to protect the wheel bolts and should be installed again after the wheel  
change.  
Wheel covers  
Fig. 178 Pulling the wheel cover off.  
Please first read and note the introductory information and heed the WARNINGS  
Pulling off the wheel cover  
Take the lug wrench and wire clip out of the vehicle tool kit Vehicle tool kit.  
Place the wire clip hook in one of the openings of the wheel cover.  
Slide the lug wrench through the clip fig. 178 and pull the wheel cover off in the direction of the  
arrow.  
Installing the wheel cover  
Make sure that the valve cutout is aligned with the tire valve, and press the wheel cover onto the  
wheel rim. Make sure that the wheel cover is latched onto the rim along the entire circumference.  

Related Topics

Popular Owner Manuals