The anti-theft alarm system, when installed, is not activated when the vehicle is locked manually
with the key bit ,Anti-theft alarm system.
Manually locking the passenger doors
Fig. 150 On the front side of the right rear door: Emergency lock, covered by a rubber seal.
Fig. 151 On the front side of the right rear door: Locking the vehicle with the key bit in the vehicle key.
ꢀ Please first read and note the introductory information and heed the WARNINGS
The passenger door and rear doors can each be locked manually. This will not activate the anti-theft
alarm system, when installed.
ꢀ
Open the door.
ꢀ
ꢀ
Remove the rubber seal on the front side of the door. The seal is marked with a lock W⇒ꢀfig. 150.
Unfold the key bit from the remote control vehicle key, Vehicle key set.
ꢀ
Insert the key bit into the slot ⇒ꢀfig. 151. On the passenger side doors, turn the key clockwise. On
the driver side rear door, turn the key counterclockwise. If there is a colored lever instead of a slot,
press the colored lever forward.
ꢀ
ꢀ
ꢀ
Reinsert the rubber seal and completely close the door.
Make sure that the door is locked.
Repeat the procedure for other doors if necessary.
English 
