Windshield wipers and washer for Your Volkswagen Jetta 4 Door Sixth Generation (2011-2018)

Windshield wipers and washer  
Introduction  
In this section you’ll find information about:  
Indicator light  
Windshield wiper lever  
Windshield wiper functions  
Windshield wiper service position  
Checking and refilling windshield washer fluid  
More information:  
Exterior views  
Climate control  
Working in the engine compartment  
Exterior care and cleaning  
WARNING  
Windshield washer fluid without enough frost protection can freeze on the windshield and  
reduce visibility.  
Use the windshield washer system with enough frost protection for winter temperatures.  
Never use the windshield wipers/washers when it is freezing without first defrosting the  
windshield. The washer solution may freeze on the windshield and reduce visibility.  
WARNING  
Worn or dirty wiper blades reduce visibility and increase the risk of accidents and severe  
injuries.  
Always replace wiper blades that are worn, damaged, or do not keep the windshield clear.  
NOTICE  
To help prevent damage to the wiper blades and the wiper motor when it is cold outside,  
always make sure that blades are not frozen to the windshield before operating the wipers.  
Using the windshield wiper service position can be helpful in cold weather so the wipers do not  
freeze to the windshield, Windshield wiper service position.  
Applicable only in Canada  
Indicator light  
Please first read and note the introductory information and heed the WARNINGS  
Lights  
up  
Possible cause  
Proper response  
Refill windshield washer reservoir at the next  
opportunity.  
Not enough windshield washer fluid.  
When the ignition is switched on, several warning and indicator lights come on briefly for a function  
check. They go out after a few seconds.  
NOTICE  
Failure to heed warning lights or text WARNINGS can result in vehicle damage.  
Windshield wiper lever  
Fig. 75 Operating the front windshield wiper.  
Please first read and note the introductory information and heed the WARNINGS  
Move the lever to the desired position ⇒ꢀ  
:
(A)  
(B)  
(C)  
Wiper switched off.  
ꢁꢂꢂ  
ꢃꢁꢄ  
Intermittent wiping for the windshield.  
Adjust the interval settings with switch ⇒ꢀfig. 75 (1).  
Slow wiper speed.  
(D)  
(E)  
Fast wiper speed.  
ꢅꢆꢇꢅ  
1x  
One-tap wiping – brief wiping. Hold the lever pressed down longer to wipe more often.  
Pull the lever toward the steering wheel to activate the windshield washers, then  
release.  
(F)  
NOTICE  
To help prevent damage to the wiper blades and the wiper motor when it is cold outside,  
always make sure that blades are not frozen to the windshield before operating the wipers.  
Using the service position can be helpful in cold weather so the wipers do not freeze to the  
windshield, Windshield wiper service position.  
If the ignition is switched off while the wipers are running, the wipers will continue at the  
same wiping speed when the ignition is switched on again. Frost, ice, snow, leaves, and other  
objects on the windshield can damage the wipers and the wiper motor.  
Remove snow and ice from the wipers before you begin driving.  
If the wiper blades freeze to the windshield, loosen them carefully. Volkswagen  
recommends using a deicing spray.  
NOTICE  
Never switch on the windshield wipers when the windshield is dry because the windshield can  
be scratched.  
On some vehicles, the windshield wipers work only if the ignition is switched on and the engine  
hood is closed. The windshield wipers turn off automatically when the engine hood is opened.  
The intermittent wiping for the front windshield depends on the driving speed. The higher the  
speed, the faster the wipers move.  
If the wiper blades freeze to the windshield, loosen them carefully. Volkswagen recommends  
using a deicing spray.  
Windshield wiper functions  
Please first read and note the introductory information and heed the WARNINGS  
Wiper performance in different situations:  
When the vehicle is not moving:  
The wiper speed changes temporarily to the next lower  
speed.  
During intermittent wiping:  
Speed-dependent interval control: The higher the vehicle  
speed, the faster the wipers move.  
Heated washer nozzles  
The heating thaws frozen washer nozzles, but not the fluid supply hoses. When the ignition is switched  
on, the heat applied to the washer nozzles is automatically regulated depending on the outside air  
temperature.  
If there is something on the windshield, the wiper will try to wipe it away. If it continues to block  
the wiper, the wiper will stop moving. Remove the obstacle and switch the wiper on again.  
Windshield wiper service position  
Fig. 76 Windshield wiper in service position.  
Please first read and note the introductory information and heed the WARNINGS  
In the service position, the wiper arms can be lifted away from the windshield ⇒ꢀfig. 76. The wipers are  
moved to the service position as follows:  
On some vehicles, the engine hood must be closed, Working in the engine compartment.  
Switch the ignition off, turn it on briefly, and then off again.  
Press the windshield wiper lever down briefly ⇒ꢀfig. 75 (E) when the ignition is off.  
Wipers move into service position.  
Carefully fold the wiper arms back onto the windshield before driving! Switch the ignition on and press  
the windshield wiper lever down briefly ⇒ꢀfig. 75 (E). The wiper arms move back to their original  
position.  
Lifting the wiper blades and tilting them away from the windshield  
Put the wiper arms in service position ⇒ꢀ  
Do not handle the wiper blades, handle the wiper arms only at the attachment above the wiper  
blades.  
.
NOTICE  
To help prevent damage to the engine hood and the windshield wiper arms, lift the wiper  
arms away from the windshield only when they are in the service position.  
Always carefully fold the windshield wiper arms down against the windshield before driving  
the vehicle.  
Checking and refilling windshield washer fluid  
Fig. 77 In the engine compartment: Cap of the windshield washer fluid reservoir.  
Please first read and note the introductory information and heed the WARNINGS  
Check the windshield washer fluid level regularly and refill as necessary.  
There is a filter screen in the filler neck of the windshield washer fluid reservoir. The screen helps to  
keep large particles and debris from getting into and clogging the windshield washer nozzles when  
adding windshield washer fluid. Take the screen out only to clean it. If the screen is damaged or  
missing, have it replaced immediately, otherwise the system may become clogged and not work  
properly.  
Open the engine hood , Working in the engine compartment.  
The windshield washer fluid reservoir can be identified by the y symbol on its cap ⇒ꢀfig. 77.  
Check if there is still enough windshield washer fluid in the reservoir.  
Refill with an appropriate windshield washer fluid that is recommended by Volkswagen ⇒ꢀ  
Follow the directions on the container.  
.
In cold weather, always use a special windshield washer antifreeze solution that will help keep the  
water from freezing ⇒ꢀ  
Recommended cleaners  
For the warmer months, Windscreen Clear SummerG 052 184 A1 or equivalent. Mixing ratio  
1:100 (1 part concentrate to 100 parts water) in the windshield washer reservoir.  
All-season Windscreen ClearG 052 164 A2 or equivalent. Mixing ratio in winter to 0 °F (-18 °C)  
.
about 1:2 (1 part concentrate to 2 parts water), otherwise, mixing ratio 1:4 in the windshield washer  
reservoir.  
Filling capacity  
The windshield washer fluid reservoir holds 3.1 – 4.2 quarts (about 3 to 4 liters).  
WARNING  
Never mix antifreeze or similar additives into the windshield washer reservoir. This could  
produce an oily film on the windshield, which would considerably reduce visibility.  
Use clear water with a cleaning solution recommended by Volkswagen.  
If necessary, blend with a suitable windshield washer fluid antifreeze agent.  
NOTICE  
Never mix cleaning solutions recommended by Volkswagen with other cleaning agents. If  
you do, this could cause sediments or other by-products that can clog the windshield washer  
nozzles.  
When refilling, do not confuse one type of operating liquid with another! Otherwise serious  
malfunctions and engine damage can occur!