authorized Volkswagen Service Facility.
/
electronic parking brake button malfunction
If the electronic parking brake button is pressed, the
be continuously lit.
red warning light will blink and the yellow central warning light will
The button may be faulty or is pulled for more than 30 seconds on a large uphill gradient.
1. If the button has been pulled for an extended period of time on an uphill gradient, press the brake pedal, release the
button and switch the ignition off and on again.
Or: to switch on the electronic parking brake without using the button on a flat surface, switch off the ignition.
2. Check whether the
warning light is continuously lit.
3. If there is a faulty button, contact a suitably qualified professional for assistance. Volkswagen recommends contacting an
authorized Volkswagen dealer or authorized Volkswagen Service Facility.
The electronic parking brake does not switch off
The requirements for switching off the electronic parking brake are not met ⇒ Electronic parking brake.
The 12 V vehicle battery is drained ⇒ Start the engine.
The electronic parking brake does not switch off if you start driving with just the clutch pedal and with a gear
engaged
Manual transmission: The vehicle was parked with a gear engaged. After the engine is started, the driver starts in the engage
gear and “releases” the clutch. The vehicle locks during start-up.
1. Stop the vehicle with the brake pedal and disengage the gear.
2. From the neutral position N, engage first gear or reverse gear and repeat the procedure for starting the vehicle.
Information about the parking systems
Safety instructions
Sensor and camera boundaries
Various sensors and cameras that detect the vehicle surroundings ultrasonically, by radar waves, and visually are located on
and in the vehicle. The various parking systems use different combinations of sensors. All sensors have technical and physica
limits ⇒
In some situations, some objects may not be detected, e.g. trailer draw bars, narrow poles, fences, posts, and trees,
extremely low or high obstacles, or trunk lids that are opening or already open ⇒
:
.
The parking system coverage areas have “blind” spots in their range where they cannot detect people and objects.
Dirt, ice, or water on the sensors and cameras may be detected as obstacles or prevent the detection of objects in some
cases. In addition to dirt and snow, soap residue or other coatings can also impair the sensor range → page , Exterior
care and cleaning.
External noises and certain surfaces on objects and clothing can affect the sensor signals. In some situations, people an
objects may not be detected or may be detected incorrectly.
Certain objects, such as small posts or grating, cannot be shown or cannot be adequately shown due to the resolution of
the screen and if there is insufficient lighting.
The cameras only show two-dimensional images on the screen. Due to the lack of depth of field, it may be difficult or
impossible to identify protruding objects or recesses in the road.
245