Installation location
The onboard supply control unit is fitted in a bracket
on the left under the dash panel.
The picture shows a view from the engine
compartment through a cut-out opening
in the bulkhead.
S453_069
Function
The range of functions depends on the equipment. More complex equipment extends the range of functions
compared to the more straightforward equipment, as shown by the functions listed in the table.
The functions listed in the table include those functions that are used in the T5 2010 with its current equipment - the
full range of possible functions of the onboard supply control unit is more extensive.
Control unit version
Range of functions of onboard supply control unit
Medium ++
-
-
-
-
-
-
-
-
-
-
-
Load management
-
-
-
-
-
-
-
-
Side light and parking light control
Seat heater and tilting/sliding sunroof enable
Central locking
Control of electric fuel pump
Terminal control/terminal registration
Front and rear wiper control
Horn control
Anti-theft alarm
Radio remote control (433 MHz)
Diagnostic interface for data bus
CAN diagnosis, driveline and convenience
LIN data bus door (driver and front passenger
door, multifunction steering wheel)
LIN data bus roof (rain/light sensor, interior
monitor/tilt sensor)
Battery isolation relay control
Heated rear window control
Heated exterior mirror control
Headlight washer system control
Interior light control
-
Brake light and turn signal/hazard warning
light control
High+
Lights
-
-
-
-
-
Shift lock and starter interlock
Reversing light control (DQ500 only)
Cruise control system
Fog light/static turning light control
LIN data bus anti-theft alarm (alarm horn)
-
-
-
-
-
-
Enable/read in main beam, light flash
Automatic running light, coming home, leaving home
Low beam, number plate light, daytime running light control
Rear fog light control
Reversing light control
Additional variant for radio remote control (315 MHz)
45
English 
