Changing a wheel -> Lifting the vehicle with the vehicle jack for Your Volkswagen Passat SUV Seventh Generation (2010-2014)

Lifting the vehicle with the vehicle jack  
Fig. 191 Lift points for the jack.  
Fig. 192 Jack in position at the left rear lift point.  
¤ Please first read and note the introductory information and  
heed the WARNINGS  
The jack must be positioned at one of the 4 lift points marked on the  
vehicle body (2 on each side as shown in fig. 191). You must use  
the lift point closest to the wheel being changed ꢀ  
.
The vehicle may only be lifted by a jack positioned at one of the  
4 jack lift points.  
Checklist  
For your own safety and that of your passengers, carry out the follow-  
ing steps in the order listed ꢀ  
:
1. Find a level spot on firm ground for lifting the vehicle.  
2. Switch off the engine. Automatic transmission: shift the transmis-  
sion into Park (P)) Automatic transmission: Selector lever. Man-  
ual transmission only: shift into a gear Manual transmission:  
Gearshift lever. Then set the electronic parking brake Braking  
and parking to help prevent the vehicle from moving.  
3. If towing a trailer: Unhitch the trailer from the vehicle and park the  
trailer properly.  
4. Straighten the steering wheel so that the front wheels point straight  
forward.  
5. Block the diagonally opposite wheel with chocks or other suitable  
things.  
6. Loosen the wheel bolts of the wheel to be changed Wheel bolts.  
7. Find the jack lift point fig. 191 on the vehicle frame that is closest  
to the wheel to be changed.  
8. Crank up the jack so that it still just fits underneath the lift point.  
9. Position the jack so that its base is directly underneath the lift point  
fig. 192, making sure that the entire base of the jack rests se-  
curely on the ground.  
10.  
the claw cradles the vertical rib underneath the vehicle fig. 192.  
11. Continue cranking up the jack until the wheel is just a little off  
the ground.  
Align the jack and wind up the jack claw at the same time, until  
WARNING  
Improper use of your vehicle jack can cause the vehicle to fall  
off the jack leading to serious personal injury. To help reduce  
the risk of serious personal injury:  
Use only jacks approved by Volkswagen for the vehicle. Oth-  
er jacks might slip, even those approved for other Volkswagen  
models, but not for your vehicle.  
Always set up the jack on firm and level ground. The vehicle  
may slip off the jack if the jack is resting on soft or sloping  
ground. If necessary, place a sturdy board under the jack.  
On a hard, slippery surface (such as a tiled floor), use an anti-  
skid rubber mat or something similar to help prevent the jack  
from slipping.  
Position the jack only at the described vehicle lift points. Be-  
fore you raise your vehicle, always make sure the jack claw  
properly grips the vertical rib under the sill so that the jack  
does not slip off when you are raising the vehicle fig. 192.  
Never have any part of your body (such as your arm or leg)  
under the vehicle when it is supported by the jack. Never let  
other persons have any part of their body under the vehicle,  
either!  
If you must work under a vehicle raised on a floor jack, al-  
ways make sure that the vehicle is safely supported on safety  
stands intended for that purpose that are strong enough to  
support the weight of the vehicle.  
Never lift the vehicle when it is tilted or inclined to one side  
or the engine is running.  
Never lift the vehicle when more than 1 tire is flat or dam-  
aged.  
Do not start the engine while the vehicle is supported by a  
jack. Engine vibrations may cause the vehicle to slip off the  
jack.  
WARNING  
Disregarding the safety-related checklist may lead to accidents  
and serious personal injuries.  
Always review and follow the checklist. Follow accepted safe-  
ty practices and use common sense.  
Lifting the vehicle with the vehicle jack (CC R-Line)  
Fig. 193 Vehicle jack lift point in the side sill: Fold the cover up.  
Fig. 194 Jack in position at the left rear lift point.  
¤ Please first read and note the introductory information and  
heed the WARNINGS  
The jack must be positioned at one of the 4 lift points located behind  
covers on the vehicle frame. The covers must be open fig. 193 to  
position the jack properly fig. 194. You must use the lift point clos-  
est to the wheel being changed.