Please carry out each step only in the order specified:
Insert the wire bracket into the opening ⇒ꢀfig. 204 (1) on the
cover and pull it forward in the direction of the arrow with the
3.
cover and remove.
4.
6.
7.
8.
Remove the screws (2) with the screwdriver.
Pull the light out slightly.
Release the connector ⇒ꢀfig. 205 (1) and disconnect it.
Turn the bulb holder (2) counterclockwise until it stops and
then it remove it toward the rear with the bulb.
9.
Replace burned out bulbs with new bulbs that are identical to
the ones being replaced.
10.
Insert the bulb holder in the headlight and turn it clockwise
until it stops.
11.
12.
Check if the bulb is installed securely.
Connect the connector (1) on the bulb so that it clicks into
place.
13.
14.
Insert the light into the bumper.
Install the screws ⇒ꢀfig. 204 (2).
Insert the cover in the bumper opposite the direction indicated
by the arrow ⇒ꢀfig. 204. The cover must click into place
securely.
15.
16.
Make sure the cover is installed securely.
The illustrations show the right fog light. The left fog light is ar-
ranged as a mirror image of the right.
English 