1
BULB REPLACEMENT
NOTE: On vehicles equipped with High Intensity Dis-
charge Headlamps (HID), when the headlamps are
turned on, there is a blue hue to the lights. This dimin-
ishes and becomes more white after approximately
10 seconds, as the system charges.
High Intensity Discharge Headlamps (HID) — If
Equipped
The headlamps are a type of high voltage discharge tube.
High voltage can remain in the circuit even with the
headlamp switch off and the key removed. Because of Quad Headlamps — If Equipped
this, you should not attempt to service a headlamp bulb See your authorized dealer for bulb replacement.
yourself. If a headlamp bulb fails, take your vehicle to
Front Park/Turn Signal and Side Marker Lamps
an authorized dealer for service.
1. Raise the hood to access the rear of the headlamp
WARNING!
housing.
2. Twist the turn signal socket and remove from the
headlamp housing, then pull the bulb out.
A transient high voltage occurs at the bulb sockets of
High Intensity Discharge (HID) headlamps when the
headlamp switch is turned ON. It may cause serious
electrical shock or electrocution if not serviced prop-
erly. See your authorized dealer for service.
3. Push the new bulb into the socket and reinstall the
socket by twisting until locked into the headlamp
housing.
2
Front Side Marker Lamps
1. From behind the bumper fascia, or the access panel on
the air dam, twist the bulb counterclockwise, and remove
bulb.
1. Raise the hood to access the rear of the headlamp
housing.
CAUTION!
NOTE: Access is somewhat limited. You may have to
remove the inner fender well or remove the headlamp
housing for bulb replacement.
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with an oily surface, clean the
bulb with rubbing alcohol.
2. Twist the socket and remove from the headlamp
housing, then pull the bulb out.
3. Push the new bulb into the socket and reinstall the
socket by twisting until locked into the headlamp
housing.
2. Disconnect wire harness from the bulb.
3. Reconnect the wiring harness to the new bulb and
reinstall the bulb by twisting clockwise.
Fog Lamps
Center Liftgate Tail/Backup Lamps
See your authorized dealer for bulb replacement.
NOTE: Access to the fog lamp bulb is from the rear of
the fascia. On the left rear side of the fascia, remove the
push pin and lower the hinged access door on the air
dam.
English 