3
operate. A chime will sound if the Key Fob is in the If you press the power door lock switch while the sliding
ignition switch and a door is open, as a reminder to door is open, the sliding door will lock.
remove the Key Fob.
Lock Doors Automatically — If Equipped
If the Lock Doors Automatically feature is enabled, your
door locks will lock automatically when the vehicle’s
speed exceeds 15 mph (24 km/h).
The Lock Doors Automatically feature is enabled when
your vehicle is shipped from the assembly plant and can
be disabled by using the following procedure:
•
On vehicles equipped with the optional Electronic
Vehicle Information Center (EVIC), refer to “Electronic
Vehicle Information Center (EVIC)/Personal Settings
(Customer-Programmable Features)” in “Understand-
ing Your Instrument Panel” for further information.
Front Passenger Power Door Switches
•
On vehicles not equipped with the optional EVIC
perform the following steps:
1 - Window Open/Close
2 - Doors Lock
3 - Doors Unlock
1. Enter your vehicle and close all doors.
4
2. Fasten your seat belt. (Fastening the seat belt will The Lock Doors Automatically at 15 mph (24 km/h)
cancel any chiming that may confuse you during this feature can be reactivated by repeating the above men-
programming procedure.)
tioned procedure or by performing the procedure in the
EVIC (if equipped), Customer-Programmable Features.
3. Place the Key Fob into the ignition.
Unlock Doors Automatically On Exit — If
Equipped
The Unlock Doors Automatically On Exit feature unlocks
all of the doors of the vehicle when any door is opened.
This will occur only after the gear selector lever has been
4. Within 15-seconds, cycle the ignition Key Fob from the
LOCK position to the ON/RUN position a minimum of
five times, ending in the ON position (do not start the
engine).
5. Within 30-seconds, press the driver’s door lock switch shifted into the PARK position, after the vehicle has been
in the lock direction.
driven (the gear selector lever has been shifted out of
PARK and all doors closed).
6. A single chime will be heard to indicate the feature has
been disabled.
The Unlock Doors Automatically On Exit feature will not
operate if there is any manual operation of the power
door locks (lock or unlock).
7. To reactivate this feature, repeat the previous steps.
8. If a chime is not heard, the program mode was
canceled before the feature could be disabled. If neces-
sary, repeat this procedure.
The Unlock Doors Automatically On Exit feature can be
enabled or disabled by performing the following proce-
dure:
English 