Advertisement

Advertisement

Remote Starting System for Your Volkswagen Routan SUV First Generation (2009-2014)

1
REMOTE STARTING SYSTEM — IF EQUIPPED  
This system uses the Remote Keyless Entry  
(RKE) transmitter to start the engine conve-  
niently from outside the vehicle while still  
maintaining security. The system has a range of  
approximately 300 ft (91 m).  
Brake switch inactive (brake pedal not pressed)  
Ignition key removed from ignition switch  
Battery at an acceptable charge level  
RKE PANIC button not pressed  
WARNING!  
NOTE: The vehicle must be equipped with an auto-  
matic transmission to be equipped with Remote Start.  
Do not start or run an engine in a closed garage or  
confined area. Exhaust gas contains Carbon Mon-  
oxide (CO) which is odorless and colorless. Car-  
bon Monoxide is poisonous and can cause serious  
injury or death when inhaled.  
How to Use Remote Start  
All of the following conditions must be met before the  
engine will Remote Start:  
Shift lever in PARK  
Doors closed  
Keep Remote Keyless Entry (RKE) transmitters  
away from children. Operation of the Remote Start  
System, windows, door locks or other controls  
could cause serious injury or death.  
Hood closed  
Liftgate closed  
Hazard switch off  
2
To Enter Remote Start Mode  
Press and release the REMOTE START button  
The engine can be started two consecutive 15-minute  
cycles with the RKE transmitter. However, the ignition  
switch must be turned to the ON position before you  
can repeat the start sequence.  
on the RKE transmitter twice within five sec-  
onds. The vehicle doors will lock, parking  
lights will flash and horn will chirp twice (if  
programmed). Then, the engine will start and the vehicle  
will remain in the Remote Start mode for a 15-minute  
cycle.  
To Enter the Vehicle After Remote Start  
To enter the vehicle while the engine is running during a  
Remote Start, you must first unlock the vehicle using the  
UNLOCK button on the transmitter. After the vehicle is  
unlocked, you can enter the vehicle, insert the Key Fob  
into the ignition switch and move it to the ON position,  
otherwise the engine will shut off at the end of 15- minute  
cycle.  
NOTE:  
If your power door locks were unlocked, Remote Start  
will automatically lock the doors.  
The park lights will turn on and remain on during  
Remote Start mode.  
To Exit Remote Start Mode and Drive the Vehicle  
Before the end of the 15-minute cycle, press and release  
the UNLOCK button on the RKE transmitter to unlock  
the doors and disarm the Vehicle Security Alarm (if  
equipped). Then, prior to the end of the 15-minute cycle,  
insert the Key Fob into the ignition switch and turn the  
switch to the ON position.  
For security, power window and power sunroof op-  
eration (if equipped) are disabled when the vehicle is  
in the Remote Start mode.  
3
NOTE:  
The shift lever is moved out of PARK  
The ignition switch must be in the ON position in  
The engine is allowed to run for the entire 15-minute  
cycle  
order to drive the vehicle.  
For vehicles equipped with the Electronic Vehicle  
Information Center (EVIC), the message “Insert Key/  
Turn to ON” will flash in the EVIC until you insert the  
Key Fob. Once inserted, the message “Turn to ON”  
will flash in the EVIC until you turn the Key Fob to  
ON.  
To Turn Off the Engine While in Remote Start  
Mode  
Press and release the REMOTE START button one time or  
allow the engine to run for the entire 15 minute cycle.  
NOTE: To avoid unintentional shutdowns while in the  
Remote Start Mode, the system will not allow the Remote  
Start button to shutdown the engine for two seconds after  
receiving a valid Remote Start request.  
Cancel Remote Start  
Remote Starting will also cancel if any of the following  
occur:  
The engine stalls or engine speed exceeds 2500 rpm  
Any engine warning lights come on  
The hood is opened  
The hazard switch is pressed  
4
When to Reset Remote Start  
The vehicle can be started remotely up to a maximum of  
two times. The vehicle is also allowed a maximum of one  
failed start, where the Remote Starting sequence was  
initiated but the engine stopped cranking without start-  
ing. After either of these conditions, or if the Vehicle  
Security Alarm system is alarming, or if the PANIC  
button was pressed, the vehicle must be reset by inserting  
a valid Key Fob into the ignition switch and rotating the  
Key Fob to the ON position, and then rotating the Key  
Fob back to the LOCK/OFF position.