1
WINDSHIELD WIPER AND WASHERS
The wipers and washers are operated by a switch within
the multifunction lever. Rotate the end of the multifunc-
tion lever to select the desired wiper speed.
NOTE: Always remove any buildup of snow that pre-
vents the windshield wiper blades from returning to the
off position. If the windshield wiper switch is turned off
and the blades cannot return to the off position, damage
to the wiper motor may occur.
Washer And Wiper Controls
1 — Front Mist/Washer
2 — Wiper Speeds
3 — Rear Wiper/Washer
2
1. Mist, Front Wiper and Washer
2. Intermittent, Low and High Speed Wipers
Press the end of the multifunction lever inward to the Use the intermittent wipers when weather conditions
first detent and release to clear the windshield. Pressing make a single wiping cycle, with a variable pause be-
the multifunction lever inward to the second detent will tween cycles, desirable. Rotate the end of the multifunc-
cause the washers to spray for a maximum of 10 seconds, tion lever to the first detent position, then turn the end of
or until the multifunction lever is released, and the the multifunction lever to select the desired delay inter-
wipers will cycle three times.
val. The delay can be regulated from approximately
2 seconds, to a maximum of 20 seconds between cycles.
The time delay will be doubled if the vehicle speed is less
than 10 mph (16 km/h).
NOTE:
•
If the end of the multifunction lever is depressed while
in the delay range, the wipers will operate for several
seconds after the multifunction lever is released, and Low-speed is achieved by rotating the multifunction
then resume the intermittent interval previously se- lever past the intermittent settings, to the first detent.
lected.
High-speed is achieved by rotating the multifunction
•
If the end of the multifunction lever is depressed while lever past the intermittent settings, to the second detent.
in the off position, the wipers will operate for one wipe
cycle and automatically turn off.
English 