Advertisement

Advertisement

Vehicle diagnostic, testing and information systems -> 1.1 Connecting vehicle diagnostic tester for Your Volkswagen Sharan VAN First Generation (1995-2010)

Bora 1999 ➤ , Bora Variant 1999 ➤ , CC 2010 ➤ , Eos 2006 ➤ , Golf 199 ...  
Electrical System, General Information - Edition 07.2010  
97 – Wiring  
1
Vehicle diagnostic, testing and infor‐  
mation systems  
WARNING  
♦ During testing or measuring operations using a vehicle di‐  
agnostic information system, there is a risk of serious or  
even fatal injury!  
♦ If the vehicle diagnostic information system is lodged in  
the activity area of an airbag during a testing or measuring  
operation, a triggered airbag can result in serious or even  
fatal injury!  
♦ During testing and measuring operations, work with a per‐  
son who can operate the vehicle diagnostic and informa‐  
tion system from one of the back seats.  
lk  
Note  
All the operations described, e.g. adaptation, coding, etc. can  
be performed using the vehicle diagnostic tester .  
All work procedures can be found in „guided fault finding“ and  
„guided functions“ modes.  
Additional information  
⇒ Self-study programme No. 202 ; Vehicle diagnostic, testing  
and information system VAS 5051  
⇒ Self-study programme No. 256 ; VAS 5052  
⇒ Self-study programme No. 294 ; Online connection of VAS  
5051  
– Connecting vehicle diagnostic tester ⇒ page 78  
1.1  
Connecting vehicle diagnostic tester  
Note  
Observe the latest operating instructions for vehicle diagnostic  
tester , which are displayed after selecting the „Administration“  
and „Operating Manual“ keys.  
Special tools and workshop equipment required  
78  
Rep. gr.97 - Wiring  
Bora 1999 ➤ , Bora Variant 1999 ➤ , CC 2010 ➤ , Eos 2006 ➤ , Golf 199 ...  
Electrical System, General Information - Edition 07.2010  
♦ Vehicle diagnostic tester  
♦ Diagnostic cable -VAS 5051/6A- (5 m)  
♦ Diagnostic cable -VAS 5051/5A- (3 m)  
lk  
Note  
Only these cables are to be used for diagnosis, as they are the  
only ones fitted with CAN wiring and therefore allowing CAN di‐  
agnosis and/or CAN communication.  
Connecting vehicle diagnostic tester :  
– Apply handbrake.  
– Vehicles with automatic gearbox, move selector lever to posi‐  
tion „P“ or „N“.  
– Vehicles with manual gearbox, move gearstick to neutral po‐  
sition.  
– With ignition switched off, connect vehicle diagnostic tester  
using diagnostic cable -VAS 5051/6A- to diagnostic interface  
-arrow- in vehicle.  
– Switch on ignition.  
– Switch off all electrical consumers.  
Note  
All other and the following vehicle diagnostic, testing and infor‐  
mation systems or vehicle diagnostic and service information  
systems are connected accordingly in the sequence described  
above.  
1. Vehicle diagnostic, testing and information systems  
79