Advertisement

Advertisement

Charging battery -> 3.5 Midtronics -INC 940- battery charger only for USA/Canada for Your Volkswagen Sharan VAN First Generation (1995-2010)

Bora 1999 ➤ , Bora Variant 1999 ➤ , CC 2010 ➤ , Eos 2006 ➤ , Golf 199 ...  
Electrical System, General Information - Edition 07.2010  
3.5  
Midtronics -INC 940- battery charger on‐  
ly for USA/Canada  
Warning and safety regulations ⇒ page 2  
General description ⇒ page 55  
Charge battery ⇒ page 56 .  
lk  
Dealing with problems with Midtronics -INC 940- battery tester  
⇒ page 58  
3.5.1  
General description of Midtronics -INC  
940- battery tester  
Batteries in VW vehicles are only allowed to be charged with bat‐  
tery chargers approved by VW. In the USA/Canada, it is permitted  
for the Midtronics -INC 940- battery charger to be used.  
Midtronics -INC 940- battery charger combines battery charging  
with a charge condition checks and a battery test.  
The following charging and analysis procedures apply to all bat‐  
teries, all battery installation locations (engine compartment or  
luggage compartment) and battery application purposes (starter  
battery or second/convenience battery).  
Always comply with the safety regulations, the regulations for  
setting up the battery charger, the display menu/display buttons,  
LEDs and the operating procedures described in the ⇒ operating  
manual INC 940 .  
Read through ⇒ operating manual INC 940 carefully.  
Refer to ⇒ Self-study programme No. ; Vehicle batteries for more  
information.  
WARNING  
Danger of injury! Observe warning notices and safety regula‐  
tions ⇒ page 2 !  
No naked flames, sparking or smoking in the vicinity of batter‐  
ies.  
Battery charger must be switched off before cables are con‐  
nected or disconnected.  
Do not remove cell plugs during charging.  
Overcharging sulphated batteries can lead to explosions.  
Do not store precision tools in rooms where batteries are  
charged, because corrosion can ensue due to chemical reac‐  
tions.  
WARNING  
Batteries where the magic eye is colourless or light yellow must  
not be checked or charged. Do not slave/jump start the vehicle!  
Danger of explosion when checking and charging or slave/  
jump starting  
These batteries must be renewed.  
3. Charging battery  
55  
Bora 1999 ➤ , Bora Variant 1999 ➤ , CC 2010 ➤ , Eos 2006 ➤ , Golf 199 ...  
Electrical System, General Information - Edition 07.2010  
3.5.2  
Charging battery  
Prerequisites:  
WARNING  
Batteries where the magic eye is colourless or light yellow must  
not be checked or charged. Do not slave/jump start the vehicle!  
Danger of explosion when checking and charging or slave/  
jump starting  
These batteries must be renewed.  
INC 940 initial setup performed (dealership number, date/time) ⇒  
operating manual INC 940 .  
– Check general information ⇒ page 55 .  
– Open bonnet or cover for other installation location of battery.  
lk  
– Perform visual check of battery ⇒ page 6 .  
– Determine whether battery type is „Standard“ (wet battery) or  
„AGM“ (absorbent glass mat battery).  
– Close all vehicle doors.  
Note  
Battery temperature must be at least 10 °C.  
For additional information, refer to the ⇒ operating manual  
INC 940 .  
Perform charging procedure:  
– Switch off all electrical consumers.  
– Switch off ignition and remove ignition key.  
– Connect red terminal clamp „+“ of charger unit to positive ter‐  
minal on battery.  
Note  
In vehicles with start/stop function and battery monitor control unit  
-J367- fitted, black terminal clamp must be connected to body  
earth. Connecting it to battery negative terminal will cause start/  
stop system to malfunction.  
– Connect black terminal clamp „-“ of battery charger to negative  
terminal.  
– Connect Midtronics -INC 940- battery charger to an earthed  
socket.  
– Set „ON/OFF“ switch of Midtronics -INC 940- battery charger  
to „ON“.  
– Select „Automatic“ or „Manual“ charging mode.  
– Select test „In vehicle“ or „Outside vehicle“.  
– Select battery type „Standard “ or „AGM“ (absorbent glass  
mat).  
56  
Rep. gr.27 - Starter, current supply, CCS  
Bora 1999 ➤ , Bora Variant 1999 ➤ , CC 2010 ➤ , Eos 2006 ➤ , Golf 199 ...  
Electrical System, General Information - Edition 07.2010  
– Select test type „Warranty“ or „Miscellaneous“. Note additional  
details (depending on type of test).  
Note  
For additional information, refer to the ⇒ operating manual  
INC 940 .  
If necessary, make a note of menu items required for „War‐  
ranty“ test type ⇒ Warranty service circular .  
Midtronics -INC 940- battery charger tests battery and starts  
charging procedure. Display then shows one of three results, as  
well as approximate charging time.  
Result:  
Measures:  
Battery OK  
Battery can be returned to op‐  
eration.  
Charging required  
♦ Test found low charge level.  
♦ Charging starts and approx‐  
imate charging duration is  
displayed.  
♦ Achieved cold-start per‐  
formance and remaining  
charging time are displayed,  
and are updated regularly.  
Renew battery.  
Note  
Battery defective. Charging  
procedure is interrupted. Re‐  
new battery.  
lk  
In case Midtronics -INC 940- shows fault messages or text dis‐  
plays other than those listed above, please refer to  
⇒ page 58 .  
WARNING  
Stop charging if battery is liberating a lot of gas. Press „Stop“  
button on front.  
When charging and testing procedure has finished, Midtronics -  
INC 940- battery charger displays „Battery good“ or „Renew  
battery“ and total charging time.  
There are three possible messages depending on individual cir‐  
cumstance (printout for warranty, repair job, evaluation and filing):  
♦ Generate test code (only possible after automatic charging  
and test).  
♦ Print last test result (for warranty).  
♦ Display last test results.  
Note  
For additional information, refer to the ⇒ operating manual INC  
940 .  
3. Charging battery  
57  
Bora 1999 ➤ , Bora Variant 1999 ➤ , CC 2010 ➤ , Eos 2006 ➤ , Golf 199 ...  
Electrical System, General Information - Edition 07.2010  
3.5.3  
Dealing with problems with Midtronics -  
INC 940- battery tester  
Under certain circumstances, the display may show errors or  
messages according to status.  
The most frequent display messages are listed below, together  
with suggested solutions.  
Note  
For messages not listed here, please refer to ⇒ operating manual  
INC 940 .  
Display message  
Check connection.  
Measures  
– Check whether terminals of  
battery charger are firmly  
connected to battery termi‐  
nals.  
– Check battery terminals are  
tightened according to reg‐  
ulations and do not have  
corrosion.  
Terminals connected?  
System noise  
Safety function of tester.  
lk  
– Connect terminals to battery  
before starting charging pro‐  
cedure.  
– Switch off all electrical con‐  
sumers.  
– Wait until all electrical loads  
monitored by onboard sup‐  
ply control unit have switch‐  
ed off.  
– Remove ignition key.  
– Disconnect any suspect  
electrical equipment not  
connected to onboard sup‐  
ply as standard.  
Wait a few minutes and repeat charging procedure ⇒ page 56 .  
58  
Rep. gr.27 - Starter, current supply, CCS