Bora 1999 ➤ , Bora Variant 1999 ➤ , CC 2010 ➤ , Eos 2006 ➤ , Golf 199 ...
Electrical System, General Information - Edition 07.2010
– Release puller locking lugs by pressing spindle -1- in direction
of -arrow B-. Then release puller -2- by turning it briefly to left
-arrow A-. Remove puller from socket.
Note
Ensure that the puller locking lugs are not spread.
Caution
The cigarette lighter might be ejected out of the socket after
lk
the heating phase.
When the puller is mounted, the socket retaining springs are
pressed apart and the retaining force is reduced.
After removing the socket, carefully press the retaining springs
together and check if the cigarette lighter remains in the re‐
moval position after the heating phase.
– Carefully press socket retaining springs together -arrows-.
– Check if cigarette lighter remains in removal position after
heating phase and ensure it is not ejected in vehicle interior.
Installing
Install in reverse order of removal.
2.4
Removing and installing cigarette lighter
illumination bulb -L28-
Note
♦ On some vehicles, the illumination is not provided by a light
bulb, but by an LED (light-emitting diode), depending on the
equipment level. This LED is permanently attached to the re‐
taining sleeve and cannot be renewed separately.
♦ Retaining sleeves with a light bulb are available in different
versions. On the one version, the light bulb can be replaced
separately; on the other version, the light bulb cannot be re‐
placed separately. In this case, the bulb carrier has to be
replaced together with the light bulb.
Removing:
– Remove socket ⇒ page 74 .
76
Rep. gr.96 - Lights, bulbs, switches - interior
English 