Advertisement

Advertisement

General information -> Raising vehicle on lifting platform for Your Volkswagen Taigo SUV First Generation (2021-2025)

Polo 2018 ➤, Polo 2022 ➤, Taigo 2022 ➤  
Maintenance - Edition 10.2021  
3
General information  
Raising vehicle on lifting platform ⇒ page 26  
Entries in service schedule ⇒ page 28  
Severe operating conditions ⇒ page 28  
Vehicle data sticker ⇒ page 28  
Vehicle diagnostic tester ⇒ page 30  
Countries with hot climate ⇒ page 31  
Country overview for petrol not compliant with EN 228 ⇒ page  
32  
Country overview for diesel not compliant with EN 590/  
EN 15940 ⇒ page 33  
Motor code and motor number ⇒ page 34  
Countries with high levels of dust ⇒ page 34  
Type plate ⇒ page 35  
Shortened intervals for spark plug replacement ⇒ page 36  
3.1  
Raising vehicle on lifting platform  
Safety notes ⇒ page 26  
Lifting points for lifting platform and trolley jack ⇒ page 27  
3.1.1  
Safety information  
NOTICE  
Risk of damage to vehicle unless sufficient distance is kept  
between low-lying vehicle components and lifting platform.  
– Observe ground clearance of vehicle.  
NOTICE  
Risk of damage to lifting platform if load-carrying capacity is  
exceeded.  
– Observe load-carrying capacity of lifting platform.  
WARNING  
Risk of injury if engine starts while a gear is engaged and the  
drive wheels make contact with the ground.  
– Ensure that there is sufficient distance between the ground  
and the drive wheels.  
NOTICE  
Risk of damage to vehicle if it is raised incorrectly.  
Potential damage to underbody if the vehicle tips over.  
– Raise vehicle only at specified jacking points.  
26  
3. General information  
Polo 2018 ➤, Polo 2022 ➤, Taigo 2022 ➤  
Maintenance - Edition 10.2021  
3.1.2  
Lifting points for lifting platform  
NOTICE  
Risk of damage to vehicle if the lifting platform is not used in  
the correct manner.  
– Screw support plates of the lifting platform out far enough  
to ensure sufficient clearance between lifting arm and side  
member.  
– Only position the support plates beneath the reinforce‐  
ments of the side member.  
Front lifting point  
– Position support plate in area of side member marking (at  
vertical reinforcement of floor pan -arrow-).  
Rear lifting point  
– Position support plate in area of side member marking at  
vertical reinforcement of floor pan -arrow-.  
3. General information  
27