Advertisement

Advertisement

Driving Mode Selection and 4MOTION Active Control for Your Volkswagen Taos SUV First Generation (2022-2025)

Hill Descent Control is deactivated if the speed is higher than 30 km/h (approx. 19 mph), when the brake pedal or accelerator  
pedal is pressed, or the gradient is less than 5%.  
WARNING  
Hill Descent Control is not a replacement for the driver's attention and works only within the system limitations. Hill  
Descent Control cannot detect all driving situations and may not react, or may react with a delay, or may react in a way  
that is not desired. If you are careless, there is a risk of accidents due to unintentional vehicle movement. This can cause  
serious or fatal injuries.  
Always stay attentive and do not rely solely on the system. The driver is always responsible for control of the  
vehicle.  
Be aware that Hill Descent Control cannot hold the vehicle on the incline or brake sufficiently going downhill in  
every situation, for example if the ground is slippery or icy.  
Always be ready to brake, in particular if the ground is slippery or icy.  
Manually brake the vehicle if the vehicle moves faster despite Hill Descent Control.  
Always adapt your speed and driving style to the visibility, weather, road and traffic conditions.  
Driving Mode Selection and 4MOTION Active Control  
Introduction  
Via the driving modes, the driver can  
adapt various properties of vehicle  
systems to the current driving situation,  
the desired driving comfort, and for an  
economic driving style. The suspension,  
steering, drive, and the air conditioner  
are some of the vehicle systems that  
can be adjusted.  
Different driving modes are available depending on the vehicle equipment. The influence of vehicle systems on the individual  
driving modes depends on the vehicle equipment.  
Differentiation according to the type of drive  
Only vehicles with all-wheel drive can be equipped with 4MOTION Active Control.  
Selecting the driving mode  
The driving mode can be selected when the ignition is switched on and the vehicle is stationary or while driving.  
WARNING  
Adjusting driving modes while driving can distract from traffic. This can cause accidents and serious or fatal injuries.  
Always drive attentively and responsibly.  
If you select a driving mode while driving, the vehicle systems, except for Drive, will be switched over to the new driving mode  
immediately.  
1. When the traffic situation allows it, briefly take your foot off the accelerator pedal to enable the newly selected driving  
mode to be applied to the Drive vehicle system as well.  
Selecting the driving mode via the rotary switch  
194  
Fig. 100 In the center armrest: 4MOTION Active Control rotary switch.  
MODE button: select onroad driving modes and open the menu in the Infotainment system.  
Snow driving mode  
Onroad driving mode  
Offroad driving mode  
Offroad Custom driving mode  
1. Turn the dial until the LED next to the preferred driving mode comes on fig. 100.  
2. To switch to the onroad driving modes, press the  
Infotainment system.  
button on the dial fig. 100  
or tap Onroad driving mode in the  
Displaying information about the driving mode  
1. To display additional information about the selected driving mode, tap in the Infotainment system.  
Selecting the Custom driving mode  
1. Press the  
on the dial or turn the dial until the LED next to the Onroad driving mode comes on.  
2. To open the Custom menu, tap Adjust in the Infotainment system.  
Selecting the Offroad Custom driving mode  
1. Turn the dial until the LED next to the Offroad Individual driving mode lights up.  
Or: if the Offroad Custom driving mode is already selected, press  
on the dial fig. 100  
.
2. To open the Custom menu, tap Adjust in the Infotainment system.  
Driving mode properties  
Onroad: You can select the Eco, Comfort, Normal, Sport and Custom driving modes under the Onroad category.  
The Comfort driving mode is only available in vehicles with DCC.  
Eco: the vehicle switches to a fuel-efficient vehicle setup and supports the driver with fuel economy messages. The  
transmission automatically shifts to E in the Eco driving mode.  
the vehicle system and offers a balanced calibration, for example for everyday use.  
feel. If the Sport driving mode is selected, vehicles with an automatic transmission switch to S.  
adapt individual vehicle systems according to your preferences. Offroad: with the Offroad driving mode, acceleration  
Normal: this driving mode shows the basic settings of  
Sport: this gives the driver a sporty  
Individual: you can  
195  
can be better controlled with the accelerator pedal when driving off-road. The engine's braking efficiency is always  
available and shifting can be blocked in critical situations. The hill start assist and hill descent control are active in the  
Offroad driving mode. The dynamic cornering light is adjusted to better assist the driver when visibility is poor.  
Offroad  
Custom: an Offroad driving mode that you can expand and adjust according to your preferences. The instrument cluster  
display tells you if an Offroad driving mode has been selected.  
Snow: using the Snow driving mode can improve the  
traction on slippery or snowy ground by having a more precise transmission of power.  
NOTICE  
Using 4MOTION Active Control driving modes while driving normally may lead to increased fuel consumption and tire  
wear and an increased noise level.  
Avoid using Offroad driving modes in normal road conditions.  
Standard behavior of the driving mode and the vehicle systems  
The Normal driving mode represents the basic settings for the vehicle systems when the ignition is switched on.  
Behavior of the driving mode when switching the ignition off and on  
If you switch the ignition off and then on again, the previously selected driving mode remains selected.  
If you have previously selected the Snow, Offroad or Offroad Individual driving mode and then switch the ignition off and on  
again, the previously selected onroad driving mode will be set.  
Behavior of the Drive vehicle system when the ignition is switched off and on  
The settings for the Drive vehicle system are reset to the Normal driving mode settings when you switch the ignition off and on  
again.  
The other vehicle systems will retain their settings.  
You can change the Drive vehicle system back to the preferred driving mode.  
1. Select your desired driving mode again.  
Or: In order to reactivate the settings in the Sport driving mode, move the automatic transmission selector lever  
backwards into driving mode S.  
Troubleshooting  
gear cannot be engaged  
In the driving modes Offroad and Snow, it is not possible to switch to the  
display if an Offroad driving mode has been selected.  
gear. Information is shown in the instrument cluste  
1. A different driving mode must be selected in order to switch to the  
gear.  
The driving mode or the vehicle systems do not behave as expected  
1. Pay attention to the standard behavior of the driving mode and the vehicle systems Standard behavior of the driving  
mode and the vehicle systems.  
Offroad display  
196  
Fig. 101 In the Infotainment system: Offroad display.  
The Offroad display provides digital instruments that display additional information about the vehicle and its environment. This  
enables you to make a more precise assessment of the current driving situation.  
Open the Offroad display  
1. Press the MENU button in the Infotainment system.  
2. Tap the Vehicle function key.  
3. Tap the Selection function key.  
4. Tap the Offroad function key.  
Selecting instruments and adjusting units  
The infotainment system displays various instruments fig. 101.  
1. To switch between instruments, swipe up over the display.  
The units on some instruments can be adjusted in the Infotainment system Vehicle settings menu.  
Instruments in the Offroad display  
The selection of instruments depends on the vehicle equipment.  
Compass: The compass shows your current direction of travel.  
Steering angle display: Shows the steering angle of the vehicle. For a left lock, the value is positive. For a right lock, it i  
negative.  
Altimeter: The altimeter shows your current height above sea level.  
Coolant temperature display: The display corresponds to the temperature display in the instrument cluster.  
Oil temperature display: The display corresponds to the oil temperature display in the instrument cluster.  
Adjusting the display areas to the driving situation  
The instruments displayed can be selected according to the driving situation and the environmental and terrain conditions:  
Sandy terrain: Oil and coolant temperature display, steering angle display.  
Inclines: Steering angle display, coolant temperature display, altimeter (depending on country).  
Alpine terrain: Steering angle display, altimeter (depending on country), Compass.  
Off-road driving situations  
Introduction  
197