Get Dynamic Road Sign Display Guide for Volkswagen Taos SUV First Generation (2022-2025)

Off-road display ⇒ Offroad display.

Volkswagen Digital Cockpit (Pro) ⇒ Volkswagen Digital Cockpit Pro, ⇒ Volkswagen Digital Cockpit Pro Information

Displays.

Volkswagen Digital Cockpit (Basic) ⇒ Volkswagen Digital Cockpit Basic, ⇒ Volkswagen Digital Cockpit Basic

Information Displays.

Active media.

Driving Data.

Vehicle status.

Radio station selection.

After starting the engine when the 12 V vehicle battery is severely drained or has been replaced or jump-started, system

settings, e.g. personal convenience settings and programming, may be adjusted or deleted. Check and correct the settings

after the 12 V vehicle battery is sufficiently recharged.

WARNING

If the driver is distracted, accidents and serious injuries can occur. Operating the Infotainment system can distract you

from trafﬁc.

Always drive attentively and responsibly.

Adjust settings in the Infotainment system only when the vehicle is stationary.

Dynamic Road Sign Display

Introduction

The Dynamic Road Sign Display

detects standard road signs using a

camera in the interior rearview mirror

base and informs the driver of

detected speed limits and passing

restrictions. Within the system limits,

the system also displays an additional

sign to indicate special restrictions. The

system may also continue to display

the valid speed limit on roads without

signs.

The trafﬁc signs recorded by the Dynamic Road Sign Display are shown in the display of the Volkswagen Digital Cockpit.

Depending on the Infotainment system installed in the vehicle, the road signs may also be displayed there.

Dynamic Road Sign Display is always active when the ignition is started.

Road sign display

Fig. 20 In the instrument cluster display: recognized speed limits (general example).

After checking and evaluating the information from the camera, the Infotainment system, and the current vehicle data, the

Dynamic Road Sign Display function displays up to two valid trafﬁc signs and a generic additional sign ﬁg. 20:

1st position: The road sign that is currently valid is shown on the left-hand side of the display, for example a speed limit of

20 mph (approx. 35 km/h).

2nd position: Another road sign can be displayed in the second position, such as a passing restriction.

Additional signs: A recognized additional sign is displayed above the applicable traffic sign. Depending on the system, a

generic additional sign is displayed instead of the actually recognized additional sign. The applicable traffic sign in

the display of the instrument cluster is supplemented by the generic additional sign.

WARNING

The Dynamic Road Sign Display is not a replacement for the driver's attention and works only within the system

limitations. This means that the Dynamic Road Sign Display cannot detect all road signs and may not react, or may react

with a delay, or may react in a way that is not desired. Driving recommendations and road signs displayed in the Dynamic

Road Sign Display may differ from the actual trafﬁc situation.

Observe the system limitations ⇒ Limits of the Dynamic Road Sign Display .

Always stay attentive and do not rely solely on the system. The driver is always responsible for control of the

vehicle.

Trafﬁc signs on the roads and trafﬁc regulations must always take precedence over driving recommendations and

displays from the Dynamic Road Sign Display function.

Always adapt your speed and driving style to the visibility, weather, road and trafﬁc conditions.

Limits of the Dynamic Road Sign Display

Please read the introductory information and heed the Warnings and Notice ⇒

Introduction.

Error messages

No road signs available. The system is in the initialization phase.

Or: the vehicle has not detected any road signs.

Error: Dynamic Road Sign Display. System malfunction. If the malfunction persists, contact a suitably qualified

professional. Volkswagen recommends contacting an authorized Volkswagen dealer or authorized Volkswagen

Service Facility.

Speed Alert currently not available. The speed alert from the Dynamic Road Sign Display is malfunctioning. If the

malfunction persists, contact a suitably qualified professional. Volkswagen recommends contacting an authorized

Volkswagen dealer or authorized Volkswagen Service Facility.

Dynamic Road Sign Display: Clean windshield! The windshield is dirty in the area around the camera or weather

conditions are interfering with the camera view. Clean the windshield.

Dynamic Road Sign Display is currently limited. Data is not being transmitted by the Infotainment system. Check that

valid map data is loaded in the Infotainment system.

Or: the vehicle is located in an area that is not detected on the map stored in the Infotainment system.

No data available. The Dynamic Road Sign Display function is not supported in the country where the vehicle is currently

being operated.

Functional limitations

The Dynamic Road Sign Display is subject to system limitations. The following conditions may cause the Dynamic Road Sign

Display function to be limited or to not operate at all:

High ambient temperature or long exposure to direct sunlight.

Poor visibility, such as in snow.

Glare, for example from oncoming trafﬁc or the sun

High speeds

If the camera is obstructed or dirty

If road signs are outside of the camera’s visual ﬁeld

If road signs are partially or completely covered, for example by trees, snow, dirt, or other vehicles.

If road signs are not in the standard format

If there are damaged or bent road signs

If there are variable trafﬁc signs on overhead signs (variable display of road signs by LED s or other lighting).

If there is outdated map material in the Infotainment system

If there are stickers on vehicles that indicate road signs, such speed limits on commercial vehicles

Operating the Dynamic Road Sign Display

Please read the introductory information and heed the Warnings and Notice ⇒

Introduction.

Speed warning

If the Dynamic Road Sign Display function detects that a valid speed limit is being exceeded, it may warn the driver audibly, o

visually and audibly, with a message in the instrument cluster display.

The speed warning can be set or completely deactivated in the Infotainment system ⇒ Vehicle settings menu. The speed

warning can be set to a value of 0 mph (0 km/h), 3 mph (5 km/h) or 5 mph (10 km/h) over the permitted speed.

Dynamic Road Sign Display for Your Volkswagen Taos SUV First Generation (2022-2025)

Popular Owner Manuals

Latest Owner Manuals