Get Emergency Assist Guide for Volkswagen Taos SUV First Generation (2022-2025)

System settings

The system settings may include the following functions, information, and setting options:

Screen.

Time and date.

Language.

Additional keyboard languages.

Units.

Voice control.

Wi-Fi^®.

Data connection.

Manage mobile devices.

Restore factory settings.

System information.

Conﬁguration assistant.

Opening system settings

1. Tap MENU Setup.

Sound settings

The sound settings may include information and setting options for equalizer, position, volume and setup.

Opening sound settings

1. Tap MENU Sound.

Adjusting the volume of external audio sources

Lower the volume of the Infotainment system before turning up the volume of an external audio source.

If the connected audio source plays too quietly, increase the output volume of the external audio source. If that does not

correct the problem, set the input volume to Medium or Maximum.

If the connected external audio source plays too loudly or the sound is distorted, lower the output volume of the external audio

source. If that does not correct the problem, set the input volume to Medium or Quiet.

Cleaning the screen

Refer to ⇒

and Safety instructions.

When cleaning the screen, please note this checklist:

The Infotainment system is switched off.

Use a soft, clean cloth that has been moistened with water.

Or: use a cleaning cloth which is available from an authorized Volkswagen dealer or authorized Volkswagen Service

Facility.

For stubborn dirt:

NOTICE

If the screen is cleaned with incorrect cleaning agents or when dry, it may be damaged.

303

Only apply gentle pressure.

Do not use any aggressive cleaners or products which contain solvents. These types of cleaners can damage the

device and cause glare on the screen.

NOTICE

If the cloth used to clean the screen is too moist, the screen can no longer be operated or switched off.

Dry the screen and then leave the vehicle locked from the outside for at least two minutes.

Radio

Introduction

In radio mode, you can receive available radio stations available via various reception modes and save your favorites to

enable quick access.

Available reception modes depend on the vehicle equipment and are not available in all countries. Reception modes may be

discontinued, switched off or no longer offered in individual countries.

In some countries, depending on the vehicle equipment, you can also use Internet Radio ⇒ Online Functions.

The radio stations are responsible for transmitted content.

Other electrical devices connected in the vehicle can impair radio signal reception and cause noise in the speakers.

Decals or metal-coated stickers on the vehicle windows can impair radio reception in vehicles with window antennas.

Function descriptions

Refer to ⇒

and Safety instructions.

Selecting a Reception Mode

Various stations are available, depending on the reception mode. The available reception modes depend on the vehicle

equipment and are not available in all countries.

1. To open the list of reception modes, tap Source.

2. Select a reception mode, e.g. FM.

Searching For and Selecting a Station

You can search for and select stations in a variety of ways. The options vary based on the reception mode.

Searching for a Station in SCAN mode

In SCAN mode, the stations in the frequency band are set automatically in succession and played for approx. 5 seconds each

1. To start SCAN mode, tap

SCAN, depending on the vehicle equipment.

SCAN mode starts and the current station is shown on the display.

The SCAN function key is shown.

2. To select a station, tap SCAN.

SCAN mode stops and the station is tuned.

Selecting a Station Using the Multi-function Steering Wheel

304

Depending on the vehicle equipment, you can select stations from the station list or favorites using the multi-function steering

wheel.

To select the previous station, press

To select the next station, press

on the multi-function steering wheel.

Selecting a Station Using a Frequency Band

1. To open the frequency band, tap

2. Tap the cursor to press and slide to the frequency band and release at the desired frequency.

Or: tap a point on the frequency band. The cursor automatically jumps to the corresponding frequency.

The station at the set frequency will be tuned.

Selecting a station from the station list

Depending on the vehicle equipment, it is possible that the station list must be manually updated if you have left the area sinc

the last time the station list was opened. The station list in the FM/DAB frequency band generally updates automatically.

1. Open the station list.

2. Tap the desired station.

The selected station will be tuned.

Selecting a Station and Saving as a Favorite

You can save up to 36 stations or frequencies from different reception modes as favorites.

Saving a Station as a Favorite

1. Tune the desired station.

2. Tap

Or: tap and hold the station on the station list.

The storage locations are displayed.

3. Tap and hold a storage location until the station is saved.

The station is saved at the selected storage location.

If a station was already saved at the storage location, this station will be removed from the storage location and replaced

by the new station.

Other Functions in Radio Mode

The functions listed below depend on the vehicle equipment and are not available in all countries.

Station logos

Station logos can be preinstalled for some frequency bands in the Infotainment system.

If the Automatic station logo selection function is activated in the settings, the station logos are automatically assigned to the

stations.

In Internet radio mode, the Infotainment system obtains the station logos from an online database and assigns them

automatically to the stations.

Switching on Automatic Station Logo Assignment

1. In radio mode, tap

and activate

Automatic station logo selection.

Assigning station logos manually

305

Emergency Assist for Your Volkswagen Taos SUV First Generation (2022-2025)

Popular Owner Manuals

Latest Owner Manuals