Get Visibility -> Rain/light sensor Guide for Volkswagen Taos SUV First Generation (2022-2025)

When parking the vehicle in cold weather conditions, moving the windshield wipers to the service position may be helpful

for loosening the wiper blades more easily from the windshield ⇒ Putting the windshield wipers in the service position .

Wiper function

Automatic rear window wiping

The rear window wiper switches on automatically when the windshield wipers are switched on and reverse gear is engaged.

The automatic activation in reverse gear function can be activated and deactivated in the vehicle settings in the Infotainment

system ⇒ Vehicle settings menu.

Heated washer nozzles

The heat thaws frozen washer ﬂuid nozzles. The heat output is automatically regulated when the ignition is switched on and is

dependent on the outside temperature. Only the window washer nozzles are heated and not the washer ﬂuid hoses.

Cleaning system of the Rear View Camera system

The cleaning system of the Rear View Camera system cleans the Rear View Camera system and works with the automatic

wiper washing system to clean the rear window.

If, after washing the camera several times, the camera's view is still limited, clean the camera lens manually ⇒ Rear view,

⇒ Exterior care and cleaning.

Rain/light sensor

Fig. 82 On the right side of the steering column: windshield wiper lever.

Switch for adjusting the sensitivity of the rain/light sensor.

Rain/light sensor deactivated.

Rain/light sensor activated, automatic wiping as necessary.

When switched on, the rain/light sensor automatically shortens or lengthens the delay between wiping cycles depending on

how hard it is raining.

Activating and deactivating the rain/light sensor

1. Press the lever into the desired position ﬁg. 82.

146

Automatic wiping can be activated and deactivated in the vehicle settings in the Infotainment system ⇒ Vehicle settings men

If automatic wiping is deactivated in the Infotainment system, the interval time will be set in ﬁxed stages.

Adjusting the sensitivity of the rain/light sensor

The sensitivity of the rain/light sensor can be manually adjusted with the switch in the windshield wiper lever ﬁg. 82 , ⇒

Move the switch to the right – high sensitivity.

Move the switch to the left – low sensitivity.

WARNING

The rain/light sensor cannot detect all precipitation sufﬁciently and activate the windshield wipers accordingly. Reduced

visibility can cause accidents and serious or fatal injuries.

If necessary, switch on the windshield wipers manually if water on the windshield is impairing visibility.

Troubleshooting

Washer ﬂuid level too low

The yellow indicator light turns on.

1. Fill the washer ﬂuid reservoir ⇒ Washer ﬂuid.

Windshield wiper malfunction

The yellow indicator light turns on.

The windshield wipers are not working.

1. Contact a suitably qualiﬁed professional. Volkswagen recommends contacting an authorized Volkswagen dealer or

authorized Volkswagen Service Facility.

Rain/light sensor malfunction

The yellow indicator light turns on.

The windshield wipers will not be automatically activated in rain/light sensor mode when it is raining.

1. Contact a suitably qualiﬁed professional. Volkswagen recommends contacting an authorized Volkswagen dealer or

authorized Volkswagen Service Facility.

Changes to rain/light sensor reaction

Some possible reasons for malfunctions and misinterpretations in the sensor area of the rain/light sensor ⇒ View from the

front could be:

Damaged wiper blades: damaged wiper blades can leave a ﬁlm of water or streaks on the window, and this can extend

the activation time, greatly shorten the wiper intervals, or cause fast wiping time.

Insects: insects hitting the windshield may trigger the wipers.

Salt streaks: salt streaks on the windshield from driving in the winter can cause the wipers to wipe more frequently or

continuously on a window that is almost dry.

Dirt: dried dust, wax, any other build-up on the windshield (lotus effect), or washing product residue (car wash) can lowe

the sensitivity of the rain/light sensor and cause it to react too slowly or not at all. Clean the sensor area for the rain/light

sensor regularly and check the wiper blades for damage ⇒ Exterior care and cleaning.

147

Crack in the windshield: if a stone strikes and chips the sensor area while the rain/light sensor is on, this will trigger a

wiper cycle. After that, the rain/light sensor will detect this irregularity on the sensor surface and react to it. Depending on

the size of the chip, the reaction behavior of the rain/light sensor may or may not change.

If there is an obstacle for the wipers on the window glass, the wipers will attempt to remove it. If it continues to block the

wipers, the wipers will stop moving.

1. Remove the obstacle and switch the wipers on again.

Mirrors

General safety precautions

Using the outside mirrors and the interior rearview mirror, the driver can observe trafﬁc and adjust their driving based on trafﬁc

For driving safety, it is important that the driver adjusts the outside mirrors and the interior rearview mirror correctly before

starting to drive.

It is not possible to oversee the entire side and rear area of the vehicle by looking in the outside and interior rearview mirrors.

These areas that are not visible are called blind spots. Other road users and objects could be in the blind spot.

WARNING

Adjusting the outside mirrors and interior rearview mirror while driving can distract the driver. This can cause accidents

and serious or fatal injuries.

Only adjust the outside mirror and interior rearview mirror when the vehicle is stationary.

Always make sure that the mirrors are adjusted correctly and visibility to the rear is not limited by ice, snow, fog, or

other objects.

WARNING

The view in the outside mirrors and interior rearview mirror does not cover the entire area around the side and rear of the

vehicle. Other road users and objects could be in these blind spots. This can cause accidents and serious or fatal injuries.

When parking, changing lanes, passing, and turning, always pay attention to your surroundings.

WARNING

Curved mirror surfaces (convex or aspheric) enlarge the ﬁeld of vision and allow objects in the mirror to appear smaller

and farther away. This can make it difﬁcult to estimate the exact distance from the vehicles behind, e.g. when changing

lane. This can cause accidents and serious or fatal injuries.

Use the interior rearview mirror as much as possible to more accurately determine the distance to vehicles or other

objects behind you.

Make sure there is sufﬁcient visibility of the area behind the vehicle.

WARNING

An automatic dimming rearview mirror contains an electrolyte ﬂuid that can leak out if the mirror glass breaks. Coming into

contact with this liquid can irritate the skin, eyes, and respiratory organs, especially in individuals with asthma or similar

illnesses. This may cause serious injuries.

148

Visibility -> Rain/light sensor for Your Volkswagen Taos SUV First Generation (2022-2025)

Related Topics

Visibility

Popular Owner Manuals

Latest Owner Manuals