Advertisement

Advertisement

Visibility -> Rain/light sensor for Your Volkswagen Tiguan 4 Door Third Generation (2024-2025)

When parking the vehicle in cold weather conditions, moving the windshield wipers to the service position may be helpful  
for loosening the wiper blades more easily from the windshield Putting the windshield wipers in the service position .  
Wiper function  
Automatic rear window wiping  
The rear window wiper switches on automatically when the windshield wipers are switched on and reverse gear is engaged.  
The automatic activation in reverse gear function can be activated and deactivated in the vehicle settings in the Infotainment  
system Vehicle settings menu.  
Heated washer nozzles  
The heat thaws frozen washer fluid nozzles. The heat output is automatically regulated when the ignition is switched on and is  
dependent on the outside temperature. Only the window washer nozzles are heated and not the washer fluid hoses.  
Heated windshield wiper area  
If the windshield wipers are in starting position, they can be heated when the temperature is approx. +4 °C (approx. +39 °F) o  
lower, depending on the vehicle equipment. The function is switched on automatically as soon as you switch on the defrost  
function or the rear window defroster, or you start the vehicle via the remote start relay function. If the vehicle is moved or the  
windshield wipers have become heated after a few minutes, then the function switches off automatically.  
Rain/light sensor  
Fig. 106 On the right side of the steering column: windshield wiper lever.  
Switch for adjusting the sensitivity of the rain/light sensor.  
Rain/light sensor deactivated.  
Rain/light sensor activated, automatic wiping as necessary.  
When switched on, the rain/light sensor automatically shortens or lengthens the delay between wiping cycles depending on  
how hard it is raining.  
Activating and deactivating the rain/light sensor  
1. Press the lever into the desired position fig. 106.  
Automatic wiping can be activated and deactivated in the vehicle settings in the Infotainment system 
Vehicle settings men  
177  
If automatic wiping is deactivated in the Infotainment system, the interval time will be set in fixed stages.  
Adjusting the sensitivity of the rain/light sensor  
The sensitivity of the rain/light sensor can be manually adjusted with the switch in the windshield wiper lever fig. 106 , ⇒  
Move the switch to the right – high sensitivity.  
Move the switch to the left – low sensitivity.  
WARNING  
The rain/light sensor cannot detect all precipitation sufficiently and activate the windshield wipers accordingly. Reduced  
visibility can cause accidents and serious or fatal injuries.  
If necessary, switch on the windshield wipers manually if water on the windshield is impairing visibility.  
Troubleshooting  
Washer fluid level too low  
The yellow indicator light turns on.  
1. Fill the washer fluid reservoir Washer fluid.  
Windshield wiper malfunction  
The yellow indicator light turns on.  
The windshield wipers are not working.  
1. Contact a suitably qualified professional. Volkswagen recommends contacting an authorized Volkswagen dealer or  
authorized Volkswagen Service Facility.  
Rain/light sensor malfunction  
The yellow indicator light turns on.  
The windshield wipers will not be automatically activated in rain/light sensor mode when it is raining.  
1. Contact a suitably qualified professional. Volkswagen recommends contacting an authorized Volkswagen dealer or  
authorized Volkswagen Service Facility.  
Changes to rain/light sensor reaction  
Some possible reasons for malfunctions and misinterpretations in the sensor area of the rain/light sensor View from the  
front could be:  
Damaged wiper blades: damaged wiper blades can leave a film of water or streaks on the window, and this can extend  
the activation time, greatly shorten the wiper intervals, or cause fast wiping time.  
Insects: insects hitting the windshield may trigger the wipers.  
Salt streaks: salt streaks on the windshield from driving in the winter can cause the wipers to wipe more frequently or  
continuously on a window that is almost dry.  
Dirt: dried dust, wax, any other build-up on the windshield (lotus effect), or washing product residue (car wash) can lowe  
the sensitivity of the rain/light sensor and cause it to react too slowly or not at all. Clean the sensor area for the rain/light  
sensor regularly and check the wiper blades for damage Exterior care and cleaning.  
Crack in the windshield: if a stone strikes and chips the sensor area while the rain/light sensor is on, this will trigger a  
178  
wiper cycle. After that, the rain/light sensor will detect this irregularity on the sensor surface and react to it. Depending on  
the size of the chip, the reaction behavior of the rain/light sensor may or may not change.  
If there is an obstacle for the wipers on the window glass, the wipers will attempt to remove it. If it continues to block the  
wipers, the wipers will stop moving.  
1. Remove the obstacle and switch the wipers on again.  
Mirrors  
General safety precautions  
Using the outside mirrors and the interior rearview mirror, the driver can observe traffic and adjust their driving based on traffic  
For driving safety, it is important that the driver adjusts the outside mirrors and the interior rearview mirror correctly before  
starting to drive.  
It is not possible to oversee the entire side and rear area of the vehicle by looking in the outside and interior rearview mirrors.  
These areas that are not visible are called blind spots. Other road users and objects could be in the blind spot.  
WARNING  
Adjusting the outside mirrors and interior rearview mirror while driving can distract the driver. This can cause accidents  
and serious or fatal injuries.  
Only adjust the outside mirror and interior rearview mirror when the vehicle is stationary.  
Always make sure that the mirrors are adjusted correctly and visibility to the rear is not limited by ice, snow, fog, or  
other objects.  
WARNING  
The view in the outside mirrors and interior rearview mirror does not cover the entire area around the side and rear of the  
vehicle. Other road users and objects could be in these blind spots. This can cause accidents and serious or fatal injuries.  
When parking, changing lanes, passing, and turning, always pay attention to your surroundings.  
WARNING  
Curved mirror surfaces (convex or aspheric) enlarge the field of vision and allow objects in the mirror to appear smaller  
and farther away. This can make it difficult to estimate the exact distance from the vehicles behind, e.g. when changing  
lane. This can cause accidents and serious or fatal injuries.  
Use the interior rearview mirror as much as possible to more accurately determine the distance to vehicles or other  
objects behind you.  
Make sure there is sufficient visibility of the area behind the vehicle.  
WARNING  
An automatic dimming rearview mirror contains an electrolyte fluid that can leak out if the mirror glass breaks. Coming into  
contact with this liquid can irritate the skin, eyes, and respiratory organs, especially in individuals with asthma or similar  
illnesses. This may cause serious injuries.  
If electrolyte fluid is swallowed, rinse out the mouth immediately for at least 15 minutes with plenty of water. Do not  
179