Get Lights and Vision -> Lights Guide for Volkswagen Touran 4 Door Third Generation (2022-2025)

Switching the turn signals on and off

1. Switch the ignition on.

2. Move the lever out of the center position into the desired position→ fig. 1.

3. To cancel the turn signal, move the lever back to its basic position.

If no chime sounds when the turn signal is on, contact suitably qualified professionals and have the vehicle checked.

Volkswagen recommends contacting an authorized Volkswagen dealer or authorized Volkswagen Service Facility.

3-blink turn signal

1. Move the lever upward or downward to the pressure point and then release the lever.

The turn signal will blink three times.

To stop the 3-blink turn signal before it ends, move the lever immediately to the pressure point in the opposite

direction and release.

The 3-blink turn signal can be activated and deactivated in the vehicle settings in the Infotainment system (→ Vehicle

settings menu).

WARNING

Using the turn signals incorrectly, not using the turn signals, or forgetting to turn the turn signal off can mislead

other road users. This can cause accidents and serious or fatal injuries.

● Always activate the turn signals correctly when changing lanes, passing, or turning.

● Switch the turn signal off again every time you finish changing lanes, passing, or turning.

The emergency flashers also work when the ignition is switched

off.

Some settings can be saved in the driver personalization user profiles and will change when the user profile is

switched.

Switching the lights on and off

Fig. 1 Next to the steering wheel: light switch(one

version).

Switching the lights on

1. Switch the ignition on.

2. Turn the light switch to the desired position→ fig. 1:

160

The daytime running light is switched on.

Automatic headlight control: the headlights will switch on or off depending on the brightness and weather

conditions → , (→ Automatic headlight control).

The parking lights and daytime running lights are switched on. The green symbol in the light switch turns on.

The low beam headlights are switched on.

Switching the lights off

1. Switch the ignition off.

2. Turn the light switch to the desired position:

The lights are switched off.

The orientation lighting can be switched on (→ Orientation lighting).

The side lights or parking lights are switched on . The green symbol in the light switch turns on.

The low beam headlights are switched off.

Vehicles with starter button: As long as the driver door is closed, the parking light continues to light up.

Daytime running lights

The optional daytime running lights can increase the visibility of your vehicle in traffic during the daytime.

If the light switch is in the ,

position (when brightness is detected), the daytime running light comes on

automatically every time the ignition is switched on.

The daytime running lights cannot be switched on or off manually.

NOTICE

If the outside temperature is very low, ice can form on the headlights. Improper cleaning can cause vehicle damage.

● Never use cleaning objects that are too hard or abrasive.

● Defrost the ice with a suitable deicer or Volkswagen Genuine deicer.

WARNING

If the vehicle lighting is not used appropriately for the weather conditions, the road will not be illuminated

sufficiently. The vehicle will not be visible to other road users or will be difficult to see. This can cause accidents and

serious or fatal injuries.

● Always turn on the low beam headlight in the dark, when it is raining, and when visibility is poor.

● Regularly check that the lighting system and turn signals are functioning correctly.

WARNING

The parking lights or daytime running lights are not bright enough to illuminate the road sufficiently and to be seen

by other road users. The taillights do not switch on with the daytime running lights. The vehicle may not be seen by

other road users in the dark, in the fog, and when visibility is poor if its taillights are not turned on. This can cause

accidents and serious or fatal injuries.

161

● Always turn on the low beam headlight in the dark, when it is raining, and when visibility is poor.

WARNING

The automatic headlights

support the driver. The driver is responsible for switching on the vehicle lighting

turn the dipped beam headlights on and off when there are changes in

correctly. The automatic headlights

brightness. Insufficient lighting on the road may cause accidents and serious or fatal injuries.

● Turn on the low beam headlights manually in certain weather conditions, such as in fog.

When reverse gear is engaged, the cornering lights on both sides of the vehicle will turn on automatically to

better illuminate the surroundings while maneuvering.

Switching the high beam headlights on and off

Fig. 1 On the left side of the steering column: turn signal

and high beam lever.

Turn on the high beam headlight.

Activate the headlight flashers or turn off the high beam headlights.

If the high beam headlights or headlight flashers are turned on, the blue indicator light will light up on the

instrument cluster display →

Turning on the high beam headlight

1. Switch the ignition on.

2. Switch on the low beam headlight.

3. Push the lever forwards out of the center position→ fig. 1

Turning off the high beam headlight

1. Pull the lever backwards out of the center position→ fig. 1

Turning the headlight flasher on and off

1. Pull the lever backwards out of the center position and hold it in place→ fig. 1

To deactivate, release the lever.

162

Lights and Vision -> Lights for Your Volkswagen Touran 4 Door Third Generation (2022-2025)

Related Topics

Lights and Vision

Popular Owner Manuals

Latest Owner Manuals