Menu
Function
The average speed will be shown after a distance of approximately
100 metres has been travelled. The display will show dashes until
this point. The displayed values will be updated approximately
every 5 seconds.
Average speed
Digital speed display
Current vehicle speed displayed digitally.
Current temperature of the coolant temperature displayed digitally.
If the --.- appears in the instrument cluster display and the
red
Digital coolant temperature
display
warning light flashes, there is a fault in the engine cooling system.
Do not drive on! Seek expert assistance.
Digital outside temperature
display
Current outside temperature displayed digitally.
If the saved speed (within the range of 30 km/h (18 mph) and
250 km/h (155 mph)) is exceeded, an acoustic warning will be
given, along with a visible warning if required.
Speed warning --- km/h
Switching between displays
•
Press the rocker switch ⇒ Fig. 12② on the windscreen wiper lever.
Setting the clocka)
•
•
•
•
•
Press and hold the
button in the windscreen wiper lever ⇒ Fig. 12① to mark the hour
display so that it flashes.
Use the rocker switch on the windscreen wiper lever ⇒ Fig. 12② to make the settings. To do
this, push the rocker switch up or down to increase or decrease the hours display.
Press the
button in the windscreen wiper lever again briefly to select the minute display
so that it flashes.
Use the rocker switch on the windscreen wiper lever to make the settings. To do this, push the
rocker switch up or down to increase or decrease the minutes display.
Press the
button on the windscreen wiper lever briefly to finish setting the clock.
Settings for the clock can also be made directly using the setting buttons on the instrument cluster
⇒ .
Saving a speed for the speed warning
•
Select the Speed warning --- km/h display.
•
Press the
button on the windscreen wiper lever to save the current speed and activate
the warning system.
•
•
If necessary, use the rocker switch on the windscreen wiper lever within approximately 5
seconds to set the desired speed. Then press
is now saved and the warning is activated.
again or wait a few seconds. The speed
To deactivate, press
. The set speed will be deleted.
Deleting memory 1 or 2 manually
•
Select the memory that you wish to delete.
•
Press and hold the button for approximately 2 seconds ⇒ Fig. 12①.
In some vehicles other functions in the multifunction display can be displayed on the screen
of the portable navigation device (delivered by Volkswagen) ⇒ Accessories, modifications, repairs
and renewal of parts.
a) Type 2 instrument cluster only ⇒ Instrument cluster.
Before the journey
Before setting off
Driving tips
Introduction
This chapter contains information on the followingsubjects:
⇒ Preparing for a journey and driving safely
⇒ Driving abroad
⇒ Driving through water on roads
Depending on where the vehicle is used, it may be advisable to have an engine and transmission
guard installed. An engine and transmission guard can reduce the risk of damage to the vehicle's
underbody and engine oil sump, for example when driving over kerbs, driveways or unsurfaced
roads. Volkswagen recommends using a Volkswagen dealership for this purpose.
English 
