In some vehicles other vehicle functions can be displayed on the screen of the portable
navigation device (delivered by Volkswagen) ⇒ Accessories, modifications, repairs and renewal of
parts.
After starting the engine with a discharged vehicle battery, or after the battery has been
changed, system settings (time, date, personal convenience settings and programming) may have
been changed or deleted. Check and correct the settings as necessary once the vehicle battery has
been sufficiently charged.
Using the displays in the instrument cluster
Fig. 12 The windscreen wiper lever: button ① to confirm and rocker switch ② to change the
display
First read and observe the introductoryinformation and safety warnings⇒
Introduction
Opening a display option
•
•
•
Switch on the ignition.
If a message or vehicle pictogram is displayed, press the
button ⇒ Fig. 12①.
Press the rocker switch ② up or down until the appropriate display option is shown.
Multifunction display (MFD)
First read and observe the introductoryinformation and safety warnings⇒
Introduction
The multifunction display (MFD) is equipped with two automatic memories: 1 - Trip memory and 2 -
Total journey memory. The number of the current memory on display will be shown in the lower
right-hand corner of the display.
When the ignition is switched on and memory 1 or 2 is shown on the
display, press the
button to switch between the two memories.
The memory collects the travel and fuel consumption data from the moment
the ignition is switched on until it is switched off.
If the journey is interrupted for more than two hours, the memory is
automatically deleted. If the journey is continued within two hours of the
ignition being switched off, the new values will be added to the existing trip
recorder.
1
2
Trip memory
Depending on which instrument cluster is installed, the memory collects
journey data for any number of individual journeys up to a total of 19 hours
and 59 minutes travel time or 1,999.9 km (miles) distance travelled. Once
these total limits have been reached, the memory will be deleted
automatically and begin again at 0.
Total journey
memory
Possible displays
Menu
Timea)
Function
Current time in hours (h) and minutes (min).
Driving time in hours (h) and minutes (min) that has elapsed since
the ignition was switched on.
Driving time
While the vehicle is in motion, current consumption is displayed
in l/100 km. When the engine is running and the vehicle is
stationary it is measured in litres/hour or, in vehicles with gas
engines, in kg/h.
Current fuel consumption
The average fuel consumption will be shown in l/100km or, in
vehicles with gas engines, in kg/100 km after a distance of
Average fuel consumption approximately 100 metres has been travelled. The display will show
dashes until this point. The displayed values will be updated
approximately every 5 seconds.
Approximate calculation of the distance in km that can still be
travelled with the current fuel level under the current driving
conditions. One factor used for calculating this figure is the current
level of fuel consumption.
Fuel range
In natural gas engines: the value with the
symbol shows the
symbol shows
total distance in petrol mode. The value with the
the total distance in petrol mode.
Distance driven
The distance travelled in km since the ignition was switched on.
English 
