Advertisement

Advertisement

Practical equipment -> Socket for Your Volkswagen Up 4 Door Second Generation (2019-2023)

Opening and closing the ashtray  
To open, lift the ashtray cover in the direction of the arrow ⇒ Fig. 90.  
To close, push the ashtray cover down as far as it will go.  
Emptying the ashtray  
Lift the ashtray out of the drink holder.  
Once it has been emptied, place the ashtray back into the drink holder from above.  
Cigarette lighter  
Fig. 91 In the front centre console: cigarette lighter  
First read and observe the introductoryinformation and safety warnings⇒  
Introduction  
With the ignition switched on, press in the knob on the cigarette lighter ⇒ Fig. 91.  
Wait for the lighter to pop out.  
Pull out the cigarette lighter and light the tobacco product on the glowing spiral ⇒  
Insert the cigarette lighter back into the socket.  
.
WARNING  
Improper use of the cigarette lighter can cause fires, burns and other serious injuries.  
Always use the cigarette lighter properly, and only use it to light tobacco products.  
Never leave children in the vehicle unattended. The cigarette lighter can be used when the  
ignition is switched on.  
The opening for the cigarette lighter can also be used as a 12-volt socket .  
Socket  
Introduction  
This chapter contains information on the followingsubjects:  
⇒ Socket in the vehicle  
Electrical equipment can be connected to the socket in the vehicle.  
All devices connected must be in good condition and fault-free.  
Additional information and warnings:  
Cigarette lighter ⇒ Ashtray and cigarette lighter  
Accessories, modifications, repairs and renewal of parts ⇒ Accessories, modifications, repairs  
and renewal of parts  
Consumer information ⇒ Consumer information  
WARNING  
Improper use of the socket and electrical accessories can cause fires and other severe  
injuries.  
Never leave children in the vehicle unattended. The socket and the devices connected to it  
can be used when the ignition is switched on.  
If the electrical device gets too hot, switch off the device immediately and disconnect it  
from the socket.  
NOTICE  
In order to prevent damage to the electrical system, never connect equipment that  
generates electricity, such as solar panels or battery chargers for charging the vehicle  
battery, to the 12-volt socket.  
Only use accessories that have been approved in accordance with current guidelines  
concerning electromagnetic compatibility.  
In order to avoid damage due to voltage fluctuation, always switch off any electrical  
consumers connected to the 12-volt socket before switching the ignition or the engine on  
or off. When the start/stop system automatically switches off and restarts the engine, it is  
not necessary to switch off any connected electrical consumers.  
Never connect electrical devices requiring more electrical power to a 12-volt socket. The  
vehicle's electrical system can be damaged if the maximum power output is exceeded.  
Do not leave the engine running when the vehicle is stationary.  
Using electrical appliances with the engine switched off and the ignition switched on will  
drain the battery.  
Unshielded devices can cause interference with radio reception and vehicle electronics.  
Interference with AM radio reception could occur if electrical devices are used in the vicinity  
of the aerial.  
Socket in the vehicle  
Fig. 92 Front centre console: 12-volt socket in the stowage compartment  
First read and observe the introductoryinformation and safety warnings⇒  
Introduction  
Maximum power rating  
Electrical socket Maximum power rating  
12-volt  
120 watts  
The maximum power rating of the sockets may not be exceeded. The power rating of each device  
is stated on its type plate.  
If two or more devices are connected at the same time, ensure that the overall power consumption  
of all connected electrical devices never exceeds 190 watts ⇒  
.
12-volt socket  
The 12-volt socket is located in the ashtray in the front centre console ⇒ Fig. 92 and works only  
when the ignition is switched on.  
Using electrical appliances with the engine switched off and the ignition switched on will drain the  
battery. Electrical consumers should therefore only be plugged into the sockets when the engine is  
running.  
To prevent damage due to voltage fluctuation, switch off any connected devices before switching  
the ignition or engine on or off.  
NOTICE  
Observe the operating instructions for any device that you plug into the socket.  
Never exceed the maximum power rating as this could damage the whole vehicle electrical  
system.  
12-volt socket:  
- Only use accessories that have been approved in accordance with the relevant  
guidelines on electromagnetic compatibility.  
- Never feed electricity into the socket.  
While driving  
Starting the engine, changing gear and  
parking  
Starting and stopping the engine  
Introduction  
This chapter contains information on the followingsubjects:  
⇒ Ignition lock  
⇒ Starting the engine  
⇒ Stopping the engine  
⇒ Electronic immobilizer  
Immobilizer display  
If the vehicle key is not valid or there is a fault in the system, then  
may be displayed in the  
instrument cluster. The engine cannot be started ⇒ Electronic immobilizer.  
Push-starting or towing  
For technical reasons, your vehicle must not be push-started or tow-started. Use jump leads to  
start the engine instead.  
Additional information and warnings:  
Vehicle key set ⇒ Vehicle key set  
Changing gear ⇒ Changing gear  
Braking, stopping and parking ⇒ Braking, stopping and parking  
Steering ⇒ Steering  
Pull-away assist systems ⇒ Pull-away assist systems  
Filling the tank ⇒ Filling the tank  
Fuel ⇒ Fuel  
Manual opening and closing ⇒ Manual opening and closing  
Starting the engine with jump leads ⇒ Starting the engine with jump leads  
Tow starting and towing ⇒ Tow-starting and towing