6.7
Climate Control
Manual Operation
Set the required:
• Fan speed
• Temperature
• Air flow.
The fan speed and temperature setting will show on the DISPLAY.
When using the air conditioner, mist may come out from the
vents. This is not a sign of trouble but a result of humid air being
suddenly cooled.
Setting the temperature to maximum high or low will not provide
the required temperature at a faster rate. To prevent cool air blowing
from the vents when heating immediately after starting a cold engine,
the amount of airflow is reduced until the air warms up.
The vehicle heater will continue to produce the selected
temperature regardless of in-vehicle conditions.
If dehumidifying is required, press the A/C button (button LED ON).
To stop dehumidifying press A/C button (button LED OFF).
When maximum cooling is required, set the TEMPERATURE dial to
the extreme cold position and press the AIR CIRCULATION button to
the re circulated air position ( will show in the DISPLAY), then
set a fast fan speed.
Defrost and Demist
To defrost or demist the windscreen on vehicle start up in
extreme cold weather conditions, operate the engine at
1500 rpm. Always make sure that the transmission is in P (park)
and the park brake is applied.
Press A/C. Press the airflow button.
Set the required:
• Temperature
• Fan speed.
If the engine is cold the air conditioning will not start up until the
engine has started to warm up.
For maximum defrost or demist set the temperature and fan
speed dials to maximum.
English 
