2.12
Vehicle Security
Approach Light
When approaching the vehicle the side and interior lamps can be set
to ON by pressing the APPROACH LIGHT button on the vehicle key.
The time that the lamps stay ON is programmable (Refer to
’Personalisation’, page 2.18).
Homesafe
When exiting the vehicle and the vehicle key has been removed from
the ignition control, flash the main beam (pull the left side stalk up
and release without latching) to set homesafe ON. The main beam
and rear lamps will then stay ON for a determined amount of time
and then go OFF. The time that the main beam and rear lamps stay
ON is programmable (Refer to ’Personalisation’, page 2.18).
Alarm
When the alarm has started a siren will be heard for a 25 seconds
cycle (ten cycles maximum) and the direction indicators flash for
five minutes after which the security system returns to the armed
state. The doors and trunk lid will stay locked throughout.
Markets where visible alarm signals and audible sirens are
permitted.
Stop the alarm at any time by pressing the UNLOCK button on the
vehicle key or by inserting the vehicle key into the ignition control
(position ‘II’). There is approximately a ten second delay before the
alarm is stopped).
Insert the key to position ‘II’ by using
the flat of a finger, as shown.
English 
