document_0900452a81b1b9de.book Seite 170 Donnerstag, 26. Juli 2007 9:16 09
170
Parking aid
Applies to vehicles: with Audi parking system plus
etc.) may not always be detected by the system, so take care not to
damage the vehicle in such cases.
Switching on/off
Note
• Please refer to the notes on towing ⇒ page 177.
• You can adjust the volume and pitch of the beeps ⇒ page 177.
Audi parking system plus
Fig. 185 Centre
console: Parking aid
switch
Applies to vehicles: with Audi parking system plus
Description
The Audi parking system plus is a parking aid with
acoustic signals and graphic display.
Sensors are located in the front and rear bumpers. When the
sensors detect an obstacle, you are alerted by acoustic signals
(beeps) and a graphic display. The measuring range of the sensors
starts at about:
Fig. 186 Display:
Graphical distance
display
Side
0.90 m
1.20 m
0.60 m
1.60 m
Front
Rear
Centre
Side
Switching on
Centre
– Switch on the sound system or MMI*.
The acoustic signals sound with increasing frequency as you
approach the obstacle. A warning tone will sound continuously
when the vehicle is less than approx. 0.30 m away from the obstacle.
Stop moving immediately!
– Engage reverse gear, or
– Press the switch in the centre console ⇒ fig. 185 or
next to the selector gate. You will hear a brief acknowl-
edgement tone and the diode in the switch will light up.
The volume of the warning beeps will be gradually reduced after
about 4 seconds if the vehicle remains at a constant distance from
a detected obstacle (it will not be reduced if the obstacle is closer
than 0.30 m).
Switching off
– Drive forwards faster than 10 km/h, or
English 
