2019-2025 Audi RS6 4 Door Driving -> Starting the vehicle User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Driving -> Starting the vehicle for Your Audi RS6 4 Door Fourth Generation (2019-2025)

Driving  
Mild hybrid drive: The combustion engine will  
start. Depending on the situation, the electric  
drive system may be switched on when driving off  
or manoeuvring.  
Driving  
Starting the vehicle  
Introduction  
Electrical components with a high power con-  
sumption are switched off temporarily while you  
start the engine. If the engine fails to start im-  
mediately, the starter will be switched off auto-  
matically after a few seconds. In this case, you  
should try to start the engine again after about  
30 seconds.  
Diesel engine: The engine may take a few sec-  
onds longer than usual to start on cold days.  
Please keep your foot on the brake pedal until  
the engine starts.  
Fig. 70 Centre console: Switching on the drive system  
The vehicle (ignition) and the drive system can be  
switched on separately. Electronic systems such  
as the MMI are available when the vehicle is  
switched on but the drive system is not. The vehi-  
cle can only be driven once the drive system has  
been switched on. Depending on the model, the  
term “drive system” refers to the combustion en-  
gine or the electric drive system.  
Switching off the drive system  
Stop the vehicle.  
START ENGINE STOP  
Press the  
button. The  
drive system will be switched off.  
After the engine is stopped, the radiator fan may  
remain on or turn itself back on for up to 10 mi-  
nutes, even if the ignition is switched off.  
Important: The key must be in the vehicle. When  
using the digital key, the activated digital key  
card must be in the phone compartment  
ðpage 194; the mobile device does not have to  
be in the phone compartment.  
Applies to vehicles with steering lock: The steer-  
ing will be locked if you switch off the engine in  
transmission position P and open the driver's  
door. The steering lock acts as a theft deterrent.  
Switching off the drive system in an  
emergency  
Any brief noises which may be heard when the ve-  
hicle is started and stopped are quite normal and  
no cause for concern.  
If necessary, the engine can be switched off in an  
emergency while the vehicle is still moving. De-  
pending on the vehicle’s equipment, it may only  
be possible to switch the engine back on again af-  
ter the vehicle has come to a standstill.  
Switching the drive system on  
Press and hold the brake pedal.  
START ENGINE STOP  
Press the  
button in the  
centre console. The drive system will be switch-  
ed on.  
START ENGINE STOP  
Press the  
button twice in  
quick succession or press and hold it.  
It may not be possible to start the vehicle at ex-  
tremely low outside temperatures.  
Switching the vehicle on/off  
If you only wish to switch the vehicle on/off and  
do not want to start the drive system as well,  
proceed as follows:  
The full performance is not available until the en-  
gine is warm. Certain powertrain components  
may need to be warmed up depending on the  
type of engine. During this warming up phase,  
is shown.  
START ENGINE STOP  
Press the  
button without  
pressing the brake pedal.  
97  
Driving  
Situations where the vehicle is switched off  
automatically  
leave the engine idling for about 2 minutes  
before switching it off.  
To prevent the vehicle battery from being dis-  
charged, the vehicle and, in some cases, the exte-  
rior lighting may be switched off automatically.  
Driver messages about the vehicle key  
The following driver messages may appear, de-  
pending on the equipment installed in your vehi-  
cle:  
Important:  
The start/stop system must have switched off  
the engine.  
Vehicle start system: fault. Please contact  
You must have left the vehicle more than 30  
seconds ago.  
workshop soon  
A vehicle start system fault has occurred. Drive to  
a qualified workshop soon and have the fault rec-  
tified.  
The vehicle must be switched on.  
The methods used by the vehicle for detecting  
whether you have left include the following:  
Remote control key: key not recognised. Is  
Driver’s door has been opened.  
Driver’s seat belt has been unbuckled.  
Brake pedal is not pressed.  
key still in vehicle?  
The vehicle key was removed from the vehicle  
while the drive system was active. If the vehicle  
key is not in the vehicle you will not be able to  
switch on the vehicle or restart the drive system  
after it has been switched off. You will also not be  
able to lock the vehicle from the outside.  
The vehicle will also be switched off after 30 mi-  
nutes or when you lock the vehicle from the out-  
side.  
WARNING  
Vehicle key: key not detected. Is there still a  
Never run the engine in confined spaces. The  
exhaust gases are toxic – risk of poisoning!  
Never switch off the engine until the vehicle  
is stationary. Otherwise you may not have  
the full benefit of the brake servo and power  
steering. You may need more strength to  
steer and brake the vehicle than you normal-  
ly would. This would mean a greater risk of  
accidents and serious injury, because you  
cannot steer and brake in the normal man-  
ner.  
valid key in the vehicle?  
The vehicle key and the digital key were removed  
from the vehicle while the drive system was ac-  
tive. If the vehicle key and digital key are not in  
the vehicle you will not be able to switch on the  
vehicle or restart the drive system after it has  
been switched off. You will also not be able to  
lock the vehicle from the outside while the drive  
system is active.  
Remote control key: hold against marked  
area and press start/stop button. See owner’s  
manual  
Before leaving the vehicle, secure it to pre-  
vent it from rolling away ðpage 99.  
The vehicle key battery is empty or there is radio  
interference. To start the vehicle, you must also  
hold the vehicle key against the symbol  
ðpage 97, Fig. 70.  
CAUTION  
Avoid high engine speeds, full throttle and  
extreme load conditions until the engine  
has reached its normal operating tempera-  
ture; otherwise this can damage the engine.  
If the engine has been working hard for a  
long time, there is a risk of heat building up  
in the engine compartment after the engine  
has been switched off; this could cause en-  
gine damage. For this reason, you should  
If the fault persists, drive to a qualified workshop  
soon and have it rectified.  
Hold remote control key against marked  
area or place digital key in Audi phone box. See  
owner’s manual  
98  
Driving  
The vehicle key battery is empty or there is radio  
interference. To start the vehicle, you must also  
hold the vehicle key against the symbol  
ðpage 97, Fig. 70 or place the digital key in the  
phone compartment.  
be gone for a short time. Otherwise the ve-  
hicle can roll away – risk of accident!  
Never leave your vehicle unattended while  
the drive system is active – risk of accident!  
If the parking brake is engaged, it may be re-  
leased automatically if the accelerator pedal  
is pressed. Take care when pressing the ac-  
celerator pedal and always make sure that  
position P is selected when you park the ve-  
hicle – risk of accident!  
If the fault persists, drive to a qualified workshop  
soon and have it rectified.  
Driving the vehicle  
Information on driving away, stopping and  
parking  
Always switch off the vehicle and take the  
key with you when you leave the vehicle.  
This is particularly important if persons or  
animals are left in the vehicle. They might  
otherwise unintentionally start the vehicle,  
release the parking brake or use power-oper-  
ated equipment – this could cause accidents.  
Do not leave any persons or animals in the  
vehicle when it is locked. Locked doors could  
delay assistance in an emergency, potential-  
ly putting lives at risk.  
Driving away from a standstill  
Press and hold the brake pedal.  
Start the vehicle.  
Select transmission position D or R. The park-  
ing brake will be released automatically.  
Take your foot off the brake pedal. The vehicle  
may start to creep forwards.  
Press the accelerator to increase the speed.  
If you do not drive away immediately after  
releasing the brake pedal, the vehicle may  
start to roll backwards. You should there-  
fore immediately press the brake pedal or  
apply the parking brake.  
Please note, especially when driving off and park-  
ing, that the vehicle “creeps” forwards/back. The  
drive system sets the vehicle in motion when you  
take your foot off the brake pedal.  
Securing the vehicle to prevent it from  
rolling away  
CAUTION  
Before leaving the vehicle, always secure it so  
that it cannot roll away.  
To avoid rolling back on gradients always hold  
the vehicle with the brake pedal if you have to  
stop. Do not attempt to hold the vehicle by  
keeping your foot on the accelerator. This  
could cause the drive system to overheat –  
risk of damage!  
Apply the parking brake.  
When parking on a slope, turn the steering  
wheel so that the vehicle would roll into the  
kerb if it did start to move unexpectedly.  
If this is not possible (e.g. if the vehicle has no  
electrical power), you must take additional steps  
to secure the vehicle so that it cannot roll away.  
Information on transmission positions and  
driving programs  
Only park the vehicle on a level surface.  
Block the wheels by placing suitable objects un-  
derneath both the front and rear of each wheel.  
Keeping the vehicle free to roll  
Refer to ðpage 108.  
WARNING  
Always apply the parking brake before leav-  
Fig. 71 Centre console: Selector lever  
ing your vehicle – even if you only intend to  
99  

Related Topics

Popular Owner Manuals