Heating and cooling -> Auxiliary air conditioner for Your Audi Rs Q8 SUV First Generation (2020-2026)

Heating and cooling  
If the LED lights up in orange for approx. two  
seconds, and then lights up or flashes in red or  
green, the remote control battery charge is  
low.  
tremely short period of time – risk of chemical  
burns!  
Keep the remote control out of the reach of  
children.  
If the LED flashes irregularly in green for ap-  
prox. five seconds, the auxiliary heating is disa-  
bled. The fuel level or vehicle battery charge is  
too low or a system fault has occurred in the  
auxiliary heating.  
Keep new and used batteries away from chil-  
dren.  
If the battery compartment does not close  
securely, stop using the remote control and  
keep it away from children.  
If the remote control LED flashes rapidly in or-  
ange for approx. six seconds after you press a  
button, the remote control battery needs to be  
replaced. The same applies if the LED does not  
light up at all.  
Seek a doctor’s assistance immediately if  
you suspect that a battery has been swal-  
lowed or has entered the body in any other  
way.  
For the sake of the environment  
Changing the remote control battery  
Applies to: vehicles with auxiliary heating/ventilation and re-  
mote control  
Batteries and electric/electronic equip-  
ment must be disposed of appropriately  
ðpage 381, Information on waste disposal.  
Driver messages  
Applies to: vehicles with auxiliary heating/ventilation  
The following driver messages may appear, de-  
pending on the equipment installed in your vehi-  
cle:  
Auxiliary heating/ventilation: fault. Not  
available  
Fig. 90 Remote control: Changing battery  
If this message appears, a system malfunction  
has occurred. Drive to a qualified workshop soon  
and have the fault rectified.  
Insert a screwdriver or similar in the slot on the  
side 1 .  
Prise the battery cover off upwards.  
Slide the battery cover slightly in the direction  
of the arrow and detach it.  
Insert a screwdriver or similar tool in the slot  
2 . Do not touch any other areas with the tool.  
Auxiliary air conditioner  
Description  
Applies to: vehicles with auxiliary air conditioning  
Carefully pry out the battery.  
Insert a new battery of the same type 3 .  
Put the battery cover back on and slide it in the  
opposite direction of the arrow until it clicks in-  
to place.  
The auxiliary air conditioner heats or cools the ve-  
hicle interior. The vehicle switches the auxiliary  
air conditioning on, depending on the tempera-  
ture last selected on the air conditioner console.  
The function can be used when the drive system  
is switched off.  
WARNING  
You can control the auxiliary air conditioner via  
the MMI or via the myAudi app.  
If batteries or button cells are swallowed or  
enter the body in any other way, they can  
cause severe or lethal injuries within an ex-  
Important: The high-voltage battery must be suf-  
ficiently charged.  
107  
Heating and cooling  
air conditioner immediately or press to open  
the auxiliary air conditioner menu.  
Note  
If the auxiliary air conditioning is active, the  
charging status of the high-voltage battery  
may decrease even when it is being charged.  
If the auxiliary air conditioning is on, it is  
not switched off automatically when the ve-  
hicle is started or stopped.  
Note  
To ensure that the timer operates correctly,  
check that the correct time and date are en-  
tered in the system settings ðpage 306.  
The auxiliary air conditioning can be switch-  
ed on/off immediately even if a timer has  
been set.  
Operation  
Applies to: vehicles with auxiliary air conditioning  
You can control the air conditioning in the  
vehicle interior when charging the high-volt-  
age battery via the charging timers  
ðpage 147. The performance of the air  
conditioner depends on the power rating of  
the mains connection.  
Applies to MMI: On the home screen, select CAR  
> A/C > .  
Immediate start  
You can switch the auxiliary air conditioner on/off  
immediately via the button. When the function  
is switched on, a coloured bar will light up above  
the button and the time remaining will be dis-  
played.  
Further settings  
Applies to: vehicles with auxiliary air conditioning  
Applies to MMI: On the home screen, select  
After an immediate start, the auxiliary air condi-  
tioner will continue to run for a maximum of  
30 minutes. When the vehicle is being charged  
using a sufficiently high charging capacity, the  
auxiliary air conditioning can run for up to 60 mi-  
nutes.  
CAR > A/C > > .  
A/C when unlocking  
When this function is activated, the air condition-  
er is switched on for five minutes after the vehi-  
cle is unlocked.  
Timer programming  
Convenience aux. A/C  
Applies to: vehicles with convenience auxiliary air conditioner  
You can set and activate up to two timers for the  
departure time.  
You can select whether certain convenience func-  
tions, such as the seat heating (if fitted), are to  
be activated with the auxiliary air conditioner.  
You can select the corresponding zones.  
Select a timer.  
Set the date and select Next.  
Set the time (departure time) and select OK.  
Use to activate the timer.  
If desired, set the second timer.  
Glass heating  
Applies to: vehicles with convenience auxiliary air conditioner  
and glass heating  
The departure time specifies when the vehicle in-  
terior is to reach the desired temperature. The  
departure time must be within the next six days.  
The auxiliary air conditioner will continue to run  
for approx. ten minutes after the departure time  
is reached.  
You can select whether the rear window and mir-  
rors are also to be heated when the auxiliary air  
conditioner is on.  
Driver messages  
Applies to: vehicles with auxiliary air conditioning  
After the ignition is switched off  
The following driver messages may appear, de-  
pending on the equipment installed in your vehi-  
cle:  
After the ignition is switched off, information on  
active timers is shown on the upper display. You  
can press the button to start the programmed  
108