2004-2011 BMW 1 Series 4 Door Controls -> Transporting children safely User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Controls -> Transporting children safely for Your BMW 1 Series 4 Door First Generation (2004-2011)

Transporting children safely  
or improperly installed child restraint systems  
The right place for children  
can increase the risk of injury to children.  
Always follow the installation instructions for  
the system with the greatest care.  
Do not leave children unattended in the  
vehicle; otherwise, they could endanger  
themselves and/or other persons by opening  
the doors, for example.<  
On the front passenger seat  
After installing a child restraint system on  
the front passenger seat, make sure that  
the front and side airbags for the front passen-  
ger are deactivated; otherwise, there is an  
increased risk of injury if the airbags deploy.<  
Children always in the rear  
Accident research has shown that the safest  
place for children is on the rear seat.  
Children under the age of 13 or smaller  
than 5 ft/150 cm may be transported only  
in the rear in suitable child restraint systems  
appropriate for their age, weight and size. Oth-  
erwise, there is an increased risk of injury in the  
event of an accident.<  
Seat position  
Before installing a child restraint system, move  
the front passenger seat as far back and up as  
possible to obtain the best possible position for  
the belt. Do not change the seat position after  
this.  
Children 13 years of age or older must be buck-  
led in with a safety belt as soon as there no  
longer is any child restraint system that is  
appropriate for their age, size and weight.  
Backrest width*  
The backrest width of the front passenger  
seat must be at its widest possible set-  
Exception for front passenger seat  
ting. Do not change the setting after installing  
the child seat. Otherwise, the child seat's stabil-  
ity on the front passenger seat is limited.<  
Should it be necessary to use a child  
restraint system on the front passenger  
seat, the front and side airbags for the front pas-  
senger must be deactivated. Otherwise, a child  
traveling on that seat will face a significant risk  
of injury if the airbags are triggered off, even  
with a child restraint system.<  
1. Adjust the backrest width to its widest set-  
ting, refer to page 45.  
2. Install the child seat.  
For more information on automatic deactivation  
of the front passenger airbags refer to page 83.  
Child seat security  
Installing child restraint  
systems  
Observe the child restraint system manu-  
facturer's instructions when selecting,  
installing and using child restraint systems.  
Otherwise, the protective effect may be dimin-  
ished. <  
The rear safety belts and the front passenger  
safety belt can be prevented from being pulled  
out in order to fasten child restraint systems.  
Standard child restraint systems are designed  
to be secured with a lap belt or with the lap-belt  
section of a lap-and-shoulder belt. Incorrectly  
52  
 
To lock the safety belt  
Coupe: rear seats  
1. Secure the child restraint system with the  
belt.  
2. Pull the belt strap all the way out.  
3. Allow the belt strap to retract and pull it taut  
against the child restraint system.  
The safety belt is locked.  
To unlock the safety belt  
1. Open the belt buckle.  
The anchor points for the lower LATCH  
anchors are located behind the labeled protec-  
tive caps.  
2. Remove the child restraint system.  
3. Allow the safety belt strap to retract all the  
way.  
Convertible: rear seats  
LATCH child restraint fixing  
system  
LATCH: Lower Anchors and Tethers for CHil-  
dren.  
To install and use the LATCH child  
restraint system, follow the operating and  
safety instructions provided by the manufac-  
turer of the system; otherwise, the protective  
function of the seat may be compromised.<  
The anchor points for the lower LATCH  
anchors are located at the positions indicated  
by arrows, in the gap between the seat and the  
backrest.  
Mounts for the lower LATCH anchors  
Before installing the child seat, pull the belt out  
of the area for the child restraint fixing system.  
Upper LATCH retaining strap  
Ensure that both lower LATCH anchors  
are correctly engaged and that the child  
restraint system is resting firmly against the  
backrest; otherwise, the protective function of  
the seat may be compromised.<  
Convertible  
For Canadian Customers Only.  
The following statement is required by Trans-  
port Canada.  
This vehicle is not equipped with user-ready  
tether anchorages. As such neither a child  
restraint system, nor a booster cushion, requir-  
ing the use of a tether strap can be properly  
secured in the vehicle.  
Coupe  
Use the top tether anchors to secure child  
restraint systems only; otherwise, the  
anchors could be damaged.<  
53  
 
4. Push the head restraint into its lowermost  
position.  
5. Pull the retaining strap taut.  
For child restraint systems with tether straps  
there are two additional anchors, see arrows.  
Placement of the tether strap  
Coupe  
Make sure the upper retaining strap does  
not run over sharp edges and is not  
twisted as it passes to the top anchor. Other-  
wise, the strap will not properly secure the child  
restraint system in the event of an accident.<  
1
2
3
4
5
6
7
Direction of travel  
Head restraint  
Hook for upper retaining strap  
Anchor  
Rear window shelf  
Seat backrest  
Upper retaining strap of child restraint sys-  
tem  
If necessary, fold the head restraints upward  
before use.  
1. Push the head restraint upward.  
2. Guide the upper retaining strap between  
the head restraint holders.  
3. Use the hook to clip the retaining strap to  
the anchor.  
54  
 

Related Topics

Popular Owner Manuals