2007-2013 BMW M3 4 Door Mobility -> Maintenance User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Mobility -> Maintenance for Your BMW M3 4 Door Fourth Generation (2007-2013)

Maintenance  
Service data in the remote control  
BMW Maintenance System  
Your vehicle continuously stores service-  
requirement information in the remote control  
while you are driving. Your BMW Service Advi-  
sor can read out this data from the remote con-  
trol unit, and propose an optimized mainte-  
nance approach. Whenever you take your car in  
for servicing you should therefore hand your  
BMW Service Advisor the remote control unit  
that you last used.  
Make sure that the date is always set cor-  
rectly, refer to page 82; otherwise the  
effectiveness of Condition Based Service CBS  
is not assured.<  
The BMW Maintenance System supports the  
preservation of the traffic and operating safety  
of your BMW. The objective is to optimize  
efforts with respect to minimal vehicle mainte-  
nance costs.  
Service and Warranty Information  
Booklet for US models and Warranty  
and Service Guide Booklet for  
Canadian models  
If and when you come to sell your BMW, a com-  
prehensive record of servicing will prove a sig-  
nificant benefit.  
Please consult your Service and Warranty Infor-  
mation Booklet for US models and Warranty  
and Service Guide Booklet for Canadian models  
for additional information on service require-  
ments.  
Condition Based Service CBS  
Sensors and special algorithms take the differ-  
ent driving conditions of your BMW into  
account. Condition Based Service uses this to  
determine the current and future service  
requirements. By letting you define a service  
and maintenance regimen that reflects your  
own individual requirements, the system builds  
the basis for trouble-free driving.  
BMW recommends that you have service  
and repair operations performed at your  
BMW center.  
Take the time to ensure that these service pro-  
cedures are confirmed by entries in your vehi-  
cle's Service and Warranty Information Booklet  
for US models and Warranty and Service Guide  
Booklet for Canadian models. These entries  
verify that your vehicle has received the speci-  
fied regular maintenance.<  
On the Control Display, you can have the  
remaining times or distances for selected main-  
tenance tasks and any legally prescribed dates  
displayed, refer to page 78:  
>
>
>
>
>
Engine oil  
Brake pads: separately for front and rear  
Brake fluid  
Vehicle check  
Legally mandated inspections depending  
on local regulations  
227  
tain vehicle data may be transmitted or  
recorded in order to facilitate the corresponding  
services.  
Socket for On-Board  
Diagnosis OBD  
Primary components that make up exhaust  
emissions can be checked by a device via the  
OBD socket.  
This socket is located on the driver's side to the  
left, on the bottom of the instrument panel  
underneath a cover.  
Exhaust emission values  
The warning lamp lights up:  
The exhaust emission values have  
worsened. Have the car checked as  
soon as possible.  
Canadian models display this warning  
lamp.  
The lamp flashes under certain conditions. This  
indicates excessive misfiring in the engine. If  
this happens, you should reduce your speed  
and visit your nearest BMW center as soon as  
possible. Severe engine misfiring can quickly  
lead to serious damage of emissions-related  
components, especially the catalytic converter.  
The warning lamp comes on if the gas  
cap is not properly tightened and the  
OBD system assumes that fuel vapor  
is escaping. If the gas cap is then tightened, the  
warning lamp should go out within a few days.  
Event data recorders  
Your vehicle may be equipped with one or sev-  
eral measuring or diagnostic modules or a  
device for recording or sending certain vehicle  
data or information. In addition, if you have  
signed a service contract for BMW Assist, cer-  
228  

Related Topics

Popular Owner Manuals