2004-2010 BMW M5 4 Door Controls -> Practical interior accessories User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Controls -> Practical interior accessories for Your BMW M5 4 Door Fourth Generation (2004-2010)

Practical interior accessories  
HomeLink is a registered trademark of Johnson  
Controls, Inc.<  
Integrated universal remote  
control*  
Programming  
The concept  
The integrated universal remote control can  
replace as many as three hand-held transmit-  
ters for various remote-controlled accessories,  
such as door openers and house alarm sys-  
tems. The integrated universal remote control  
registers and stores signals from the original  
hand-held transmitters.  
The signal of an original hand-held transmitter  
can be programmed on one of the three mem-  
ory buttons 1. Then with the ignition switched  
on, this programmed memory button 1 can be  
used to operate the respective feature. The  
LED 2 flashes to confirm transmission of the  
signal.  
1
2
Memory buttons  
LED  
Fixed-code hand-held transmitters  
1. Switch on ignition, refer to page 53.  
Should you sell your vehicle one day, be sure to  
delete the stored programs beforehand for your  
safety, refer to page 94.  
2. When starting operation for the first time:  
Press both outer memory buttons 1 for  
approx. 20 seconds until the LED 2 flashes.  
All stored programs are deleted.  
To prevent possible damage or injury,  
before programming or using the inte-  
grated universal remote control, always inspect  
the immediate area to make certain that no peo-  
ple, animals or objects are within the travel  
range of the device. Also, comply with the  
safety precautions of the original hand-held  
transmitter.<  
3. Hold the original hand-held transmitter at a  
distance of approx. 2 in/5 cm to 8 in/20 cm  
from the memory buttons 1.  
The required distance between the  
hand-held transmitter and the mem-  
ory buttons 1 depends on the relevant sys-  
tem of the original hand-held transmitter  
used.<  
Checking compatibility  
4. Simultaneously press the transmit key on  
the original hand-held transmitter and the  
desired memory button 1 on the integrated  
universal remote control. The LED 2 flashes  
slowly at first. As soon as the LED 2 flashes  
rapidly, release both buttons. If the LED 2  
does not flash rapidly after approx. 15 sec-  
onds, alter the distance.  
If you see this symbol on the packaging  
or in the manual supplied with the orig-  
inal hand-held transmitter, it is safe to  
assume that it is compatible with the integrated  
universal remote control.  
If you have additional questions, please  
contact your BMW center or call:  
1-800-355-3515.  
Information is also provided on the Internet at:  
5. To program other original hand-held trans-  
mitters, repeat steps 3 and 4.  
93  
The corresponding memory button 1 is now  
programmed with the signal of the original  
hand-held transmitter.  
The corresponding memory button 1 is now  
programmed with the signal of the original  
hand-held transmitter.  
You can operate the system when the engine is  
running or when the ignition is switched on.  
If you have any additional questions,  
please contact your BMW center.<  
If the device can not be used after  
repeated programming, check whether  
Deleting stored programs  
the original hand-held transmitter uses an alter-  
nating-code system. To do so, either read the  
instructions for the original hand-held transmit-  
ter or hold down the programmed memory  
button 1 of the integrated universal remote  
control. If the LED 2 on the integrated universal  
remote control flashes rapidly for a short time  
and then remains lit for approx. 2 seconds, this  
indicates that the original hand-held transmitter  
uses an alternating-code system. In the case of  
an alternating-code system, program the mem-  
ory buttons 1 as described at Alternating-code  
transmitters.<  
Press both outer memory buttons 1 for approx.  
20 seconds until the LED 2 flashes:  
All stored programs are deleted.  
Individual programs cannot be deleted.  
Sun blinds*  
Sun blind for rear window  
Alternating-code transmitters  
To program the integrated universal remote  
control, consult the operating instructions for  
the equipment to be set. You will find informa-  
tion there on the possibilities for synchroniza-  
tion.  
Press the button on the driver's door.  
When programming hand-held transmitters  
that employ an alternating code, please observe  
the following supplementary instructions:  
Sun blinds for rear side windows  
Pull the loop of the roller sun blind and hook  
onto bracket.  
Programming will be easier with the aid of  
a second person.<  
1. Park your vehicle within the range of the  
remote-controlled device.  
2. Program the integrated universal remote  
control as described above in the section  
Fixed-code hand-held transmitters.  
3. Locate the button on the receiver of the  
device to be set, e.g. on the drive unit.  
4. Press the button on the receiver of the  
device to be set. After step 4, you have  
approx. 30 seconds for step 5.  
5. Press the programmed memory button 1  
of the integrated universal remote control  
three times.  
94  
To avoid possibly damaging the lamp,  
always ensure that it is switched off  
before inserting it in the socket.<  
Glove compartment  
Opening  
Front center armrest  
The compartment is the center armrest is  
divided into two sections.  
Opening cover  
Pull the handle. The light in the glove compart-  
ment switches on.  
To prevent injury in the event of an acci-  
dent while the vehicle is being driven,  
close the glove compartment immediately after  
use.<  
Closing  
Press the button. The cover opens somewhat  
and can be folded upwards.  
Fold the cover up.  
Depending on vehicle equipment, the upper  
section contains a compartment with a mat that  
can be removed for cleaning or a telephone  
cradle*.  
Locking  
Lock with a key.  
If you only hand over the remote control  
without the integrated key, e.g. for valet  
parking, refer to page 28, the glove compart-  
ment cannot be unlocked.<  
Opening upper compartment  
Rechargeable flashlight  
Press button and fold cover upward.  
The flashlight is located on the left side of the  
glove compartment.  
The flashlight can remain plugged in continu-  
ously. Pull the flashlight out of the socket when  
needed.  
95  
Accessing lower compartment  
Storage compartments  
There are other storage compartments in the  
doors as well as in the front and rear center con-  
sole.  
Storage nets are located on the backrests of the  
front seats, and a net* is provided in the front  
passenger footwell.  
Do not stow hard or sharp-edged objects  
in the storage nets or the net, otherwise  
there is an increased risk of injury in an acci-  
dent.<  
Press the button at the front and fold the upper  
compartment or the telephone cradle upward.  
Clothes hooks  
Ventilating lower compartment  
Clothes hooks are located near the grab han-  
dles in the rear.  
Push the slide in the lower compartment  
upward.  
When hanging clothing on the hooks,  
ensure that it will not obstruct the driver's  
vision. Do not hang heavy objects on the hooks.  
If you do so, they could cause personal injury to  
occupants during braking or evasive maneu-  
vers.<  
Depending on the automatic climate con-  
trol setting, the temperature inside the  
ventilated compartment may be higher than in  
the rest of the interior. Should this be the case,  
push the slide downward to close off the venti-  
lation.<  
Adjusting  
Cup holders  
Do not place containers made of glass in  
the cup holders. This would lead to an  
increased risk of injury in the event of an acci-  
dent.<  
Opening  
Push the illustrated section of the center arm-  
rest into the desired position.  
Connection for external audio device  
You can connect an external audio device, e.g. a  
CD or an MP3 player, and play the sound via the  
vehicle loudspeakers, refer to page 151.  
Briefly press the button.  
Closing  
Press the cover in the center and push in the  
cup holder.  
96  
Ashtray, front  
Ashtray, rear  
Opening  
Slide back the cover.  
Emptying  
Emptying  
Press the entire cover down. The ashtray rises  
and can be removed.  
Push the ashtray toward the front: the ashtray  
lifts and can be removed.  
Cigarette lighter, rear  
Cigarette lighter, front  
Refer to Cigarette lighter, front.  
Connecting electrical devices  
Press in the lighter with the engine running or  
the ignition switched on.  
Sockets  
The lighter can be removed as soon as it pops  
back out.  
With the engine running or the ignition switched  
on, the cigarette lighter socket can be used as a  
power outlet for hand flashlights, car vacuum  
cleaners, etc., with power ratings of up to  
approx. 200 W at 12 V. Avoid damaging the  
socket due to inserting plugs of different  
shapes or sizes. The same is true for all power  
outlets in the vehicle.  
Hold or touch the hot cigarette lighter by  
the knob only. Holding or touching it in  
other areas could result in burns.  
Always take along the remote control when you  
leave the vehicle, otherwise children could, for  
example, use the lighter and burn themselves.<  
97  
In front passenger footwell  
Center armrest, rear  
Access to socket:  
Fold open the cover.  
Storage tray:  
Pull the cover upward, arrow 1.  
Access to cup holders:  
Press the button 2 and open the cover  
In the rear center console  
Through-loading system*  
Opening  
1. Open the buckle of the center safety belt in  
the rear and insert the latch plate at the end  
of the belt into the fixture on the rear win-  
dow shelf.  
Depending on the equipment, the sockets in  
the rear are covered with caps or equipped with  
a lighter. Refer to Cigarette lighter, front,  
page 97.  
Access to socket:  
Remove respective cap or lighter.  
In luggage compartment  
2. Push the corresponding head restraint  
down as far as it will go, refer to page 44.  
Access to socket:  
Fold open the cover.  
98  
3. To unlock the rear seat back, pull the corre-  
sponding lever in the luggage compart-  
ment.  
Ski bag*  
Designed for safe, clean transport of up to  
4 pairs of standard skis or up to 2 snowboards.  
With the ski bag you can stow skis with a length  
of up to 6.9 ft/2.10 m. When skis of 6.9 ft/2.10 m  
in length are loaded, the ski bag will tend to con-  
tract, reducing its overall capacity.  
Loading  
1. Fold down the center armrest, press the  
button and open the cover.  
4. The unlocked rear seat back moves forward  
slightly. Fold the seat back forward by the  
head restraint.  
2. Press the button again; the cover in the lug-  
gage compartment opens. If you press the  
button firmly the first time, this also opens  
the cover in the luggage compartment.  
Closing  
3. Extend the ski bag between the front seats  
and fill it. The zipper facilitates access to the  
stowed items and drying of the ski bag.  
1. Fold the rear seat back into the seating  
position and engage.  
4. Insert the latch plate of the ski bag retaining  
strap into the center safety belt buckle that  
is marked CENTER.  
When you return the seat to its upright  
position, make sure that the retainer  
engages properly. If it is not properly engaged,  
transported cargo could enter the vehicle dur-  
ing braking or evasive maneuvers and endanger  
the vehicle occupants.<  
2. Release the latch plate from the bracket on  
the rear window shelf and insert it into the  
buckle of the center safety belt. The latch  
plate must audibly engage.  
The lashing eyes in the luggage compartment  
provide you with a way to attach luggage com-  
partment nets* or flexible straps for securing  
suitcases and luggage, refer to page 108.  
Only stow clean skis in the ski bag. Wrap sharp  
edges to prevent damage.  
99  
Securing cargo  
After loading, secure the ski bag and its con-  
tents. Tighten the retaining strap on the ten-  
sioning buckle for this purpose.  
Secure the ski bag in this way. If you fail to  
do so, it could endanger occupants dur-  
ing braking or evasive maneuvers.<  
To store the ski bag, perform the above steps in  
reverse order.  
Removing ski bag  
The ski bag can be completely removed, e.g. for  
faster drying or to allow you to put it to other  
uses.  
1. Pull the handle forward and pull the ski bag  
up and out.  
2. Close the cover in the luggage compart-  
ment.  
Your BMW center will be glad to provide  
you with more detailed information on the  
various items of equipment.<  
100  

Related Topics

Popular Owner Manuals