Care -> Washing the vehicle for Your BMW X6 4 Door Second Generation (2015-2019)

Mobility  
Care  
Care  
Minimum distance from glass sunroof:  
31.5 in/80 cm.  
Vehicle features and options  
This chapter describes all standard, country-  
specific and optional features offered with the  
series. It also describes features that are not  
necessarily available in your vehicle, e. g., due  
to the selected options or country versions.  
This also applies to safety-related functions  
and systems. When using these functions and  
systems, the applicable laws and regulations  
must be observed.  
Automatic vehicle washes  
Safety information  
NOTE  
Improper use of automatic vehicle  
washes can cause damage to the vehicle.  
There is a risk of damage to property. Follow  
the following instructions:  
Give preference to cloth vehicle washes or  
those that use soft brushes in order to  
avoid paint damage.  
Washing the vehicle  
General information  
Before driving into the vehicle wash, make  
sure that the vehicle is not too large.  
Regularly remove foreign objects such as  
leaves in the area below the windshield when  
the hood is raised.  
Avoid vehicle washes with guide rails  
higher than 4 in/10 cm to avoid damage to  
the chassis.  
Wash your vehicle frequently, particularly in  
winter. Intense soiling and road salt can dam‐  
age the vehicle.  
Observe the tire width of the guide rail to  
avoid damage to tires and rims.  
Fold in exterior mirrors to avoid damage to  
the exterior mirrors.  
Steam blaster and high-pressure  
washer  
Deactivate the wiper and, if necessary, rain  
sensor to avoid damage to the wiper sys‐  
tem.◀  
Safety information  
NOTE  
When cleaning with high-pressure wash‐  
ers, components can be damaged due to the  
pressure or temperatures being too high.  
There is a risk of property damage. Maintain  
sufficient distance and do not spray too long  
continuously. Follow the operating instructions  
for the high-pressure washer.◀  
Driving into a vehicle wash with a  
Steptronic transmission  
Safety information  
NOTE  
Selector lever position P is automatically  
engaged when the ignition is switched off.  
There is a risk of property damage. Do not  
switch drive-ready state off in vehicle  
washes.◀  
Distances and temperature  
Maximum temperature: 140 ℉/60 ℃.  
Minimum distance from sensors, cameras,  
seals: 12 inches/30 cm.  
260  
Care  
Mobility  
General information  
center or another qualified service center or re‐  
pair shop.  
In a vehicle wash, the vehicle must be able to  
roll freely.  
Safety information  
Roll or push the vehicle, refer to page 83.  
WARNING  
Some vehicle washes do not permit persons in  
the vehicle. The vehicle cannot be locked from  
the outside when in selector lever position N. A  
signal sounds when an attempt is made to lock  
the vehicle.  
Cleansers can contain substances that  
are dangerous and harmful to your health.  
There is a risk of injury. When cleaning the in‐  
terior, open the doors or windows. Only use  
products intended for cleaning vehicles. Fol‐  
low the instructions on the container.◀  
Driving out of a vehicle wash  
Ensure that the vehicle key is in the car.  
Start the engine, refer to page 71.  
Vehicle paint  
General information  
Headlights  
Regular care contributes to driving safety and  
value retention. Environmental influences in  
areas with elevated air pollution or natural con‐  
taminants, such as tree resin or pollen can af‐  
fect the vehicle's paintwork. Tailor the fre‐  
quency and extent of your vehicle care to  
these influences.  
Do not rub wet headlights dry and do not use  
abrasive or acidic cleaning agents.  
Soak areas that have been dirtied, for instance  
from insects, with shampoo and wash off with  
water.  
Thaw ice with de-icing spray; do not use an ice  
scraper.  
Aggressive substances such as spilled fuel, oil,  
grease or bird droppings, must be removed im‐  
mediately to prevent the finish from being al‐  
tered or discolored.  
After washing the vehicle  
After washing the vehicle, apply the brakes  
briefly to dry them; otherwise, braking action  
can be reduced. The heat generated during  
braking dries brake discs and brake pads and  
protects them against corrosion.  
Matte finish  
Only use cleaning and care products suitable  
for vehicles with matte finish.  
Completely remove all residues on the win‐  
dows, to minimize loss of visibility due to  
smearing and to reduce wiper noises and  
wiper blade wear.  
Leather care  
Remove dust from the leather regularly, using  
a cloth or vacuum cleaner.  
Otherwise, particles of dust and road grime  
chafe in pores and folds, and lead to increased  
wear and premature degradation of the leather  
surface.  
Vehicle care  
Vehicle care products  
To guard against discoloration, such as from  
clothing, clean leather and provide leather care  
roughly every two months.  
General information  
BMW recommends using vehicle care and  
cleaning products from BMW. Suitable care  
products are available from a dealer’s service  
261