Practical information
Storing
When the bars are not in use:
-
-
-
-
partially loosen the knurled wheels,
lift the bar slightly,
pivot it upwards by 180°,
tighten the knurled wheels.
Good practice
In the event of a front impact, the rack
is disengaged to avoid injury to the
occupants of the vehicle. The slight
clearance observed in the bar is linked
with this safety disengagement.
Do not loosen or place the bars in a
position other than those described
above.
The load on the rack must rest on the
overhead storage compartment and
be strapped using the strap passages
provided on the bars.
Fitting the bars
-
-
Unscrew the knurled wheels
located at the ends of the bars fully.
Take hold of the bar by the ends
to slide them towards the inside
to retract them.
-
-
-
Carry out the same operations
on the other side.
Ensure that they are engaged
correctly at the base of the notch.
Tighten the knurled wheels and
check the tightening by pushing
the bar sideways.
The bars are not grab handles for the
passengers.
-
Extract the metal end piece A taking
hold of the end of the bar like
a syringe.
To remove, proceed in the reverse
order.
-
Insert the end piece A on one side
then lower it to fix it in the base of
the notch B.
English 
