Advertisement

Advertisement

Checks for Your Citroen C1 4 Door First Generation (2005-2014)

CHECKS  
8
OPENING THE BONNET  
On the inside: pull the release lever A,  
located under the dashboard.  
On the outside: lift the safety catch B  
and raise the bonnet.  
Bonnet stay  
Secure the stay to hold the bonnet  
open.  
To close  
Before closing the bonnet, return the  
stay to its housing.  
Lower the bonnet and release it at  
the end of its travel. Check that the  
bonnet is fully closed.  
68  
CHECKS  
8
1.0 LITRE PETROL ENGINE  
1. Coolant reservoir  
2. Screenwash reservoir  
3. Brake fluid reservoir  
4. Fusebox  
5. Battery  
6. Air filter  
7. Engine oil dipstick  
8. Engine oil filler cap  
69  
CHECKS  
CHECKING THE LEVELS  
Oil level  
8
Changing the brake fluid  
Windscreen wash level  
The brake fluid must be changed at  
the intervals stated, according to the  
manufacturer's servicing schedule.  
Use fluids recommended by the  
manufacturer, which fulfil DOT4  
standards.  
For best quality cleaning and for your  
safety, we would advise that you  
use products recommended by your  
manufacturer.  
Contact a CITROËN dealer or a  
qualified workshop.  
Check the level regularly and top up  
between changes. The maximum oil  
consumption is 0.5 litre per 600 miles  
(1 000 km).  
Check the level with the vehicle level,  
engine cold, using the dipstick.  
Cooling system  
Used oil  
Dipstick  
Avoid prolonged contact of used oil  
with the skin.  
Brake fluid is harmful to health and  
Only use the fluid recom-  
mended by the manufacturer.  
Otherwise, you risk seriously  
damaging your engine.  
There are two marks  
on the dipstick:  
A = maximum  
very corrosive.  
If you fill past this  
Do not dispose of used oil,  
brake fluid or coolant into  
drains or into the ground.  
mark,  
CITROËN dealer or a  
contact  
a
qualified workshop.  
B = minimum  
Never allow the level to  
fall below this mark.  
When the engine is warm, the  
temperature of the coolant is  
controlled by the engine fan. As this  
fan can operate with the ignition key  
removed and because the cooling  
system is pressurised, wait for at  
least one hour after the engine has  
stopped before carrying out any  
work.  
Empty the used oil into the  
containers provided for this  
purpose in the CITROËN dealer  
network or at a qualified workshop  
(France) or at an authorised waste  
disposal site.  
To maintain the reliability of  
engines and emission control  
systems, the use of additives  
in engine oil is prohibited.  
Slacken the cap by 1/4 of a  
turn to release the pressure  
to prevent any risk of  
scalding. When the pressure  
has dropped, remove the cap and  
top up the level.  
Oil change  
According to the information given in  
the servicing booklet.  
Oil viscosity grade  
In all cases, the oil selected must meet  
the manufacturer's requirements.  
70  
CHECKS  
8
Only use products recom-  
mended by CITROËN or  
products of equivalent quality  
and specification.  
Disc and drum wear  
For information on disc and drum  
surface wear, contact a CITROËN  
dealer or a qualified workshop.  
Battery  
In order to optimise the operation  
of units as important as the braking  
system, CITROËN selects and offers  
specific products.  
At the start of winter, have your  
battery checked by a CITROËN  
dealer or a qualified workshop.  
In order to avoid damaging the  
electrical units, high pressure washing  
to clean the engine compartment is  
strictly prohibited.  
Parking brake  
Where the parking brake travel is  
too great or there is a reduction in  
the performance of the system, the  
parking brake should be adjusted,  
even between services.  
Air filter and passenger  
compartment filter  
Have the filter elements replaced  
regularly. If you drive in dusty  
conditions, change them twice as  
often.  
Have the system checked by a  
a
CITROËN dealer or  
workshop.  
qualified  
Brake pads  
Oil filter  
Brake pad wear depends on the style  
of driving, in particular for vehicles  
which are used in town, over short  
distances.  
Change the filter regularly, in accor-  
dance with the servicing schedule.  
Manual gearbox  
It may be necessary to check  
the thickness of the pads,  
even between services.  
Have the level checked in accord-  
ance with the manufacturer's servic-  
ing schedule.  
To check the main levels and certain  
components, in accordance with the  
manufacturer's servicing schedule,  
refer to the pages of the servicing  
booklet which correspond to your  
vehicle's engine.  
71