Get In the event of a breakdown -> Spare wheel Guide for Citroen C1 4 Door Second Generation (2014-2022)

In the event of a breakdown

Spare wheel

Procedure for replacing a wheel with a damaged tyre by the spare wheel using the tools supplied with the vehicle.

Parking the vehicle

F

As far as possible, immobilise the vehicle

on level, stable, non-slippery ground.

Apply the parking brake.

Switch off the ignition ("OFF" mode for

vehicles fitted with "Keyless Entry and

Starting").

F

If necessary, chock the wheel diagonally

opposite the wheel to be changed.

You must ensure that the occupants leave

the vehicle and wait in a safe location.

F

Engage first gear or reverse for a manual

gearbox.

Place the gear selector at position N for an

ETG electronic gearbox.

158

In the event of a breakdown

Access to the spare wheel

and tools

All of these tools are specific to your

vehicle and can vary according to

equipment. Do not use them for any

other purposes.

Never go underneath a vehicle

supported only by a jack (use an axle

stand).

Never use a jack other than the one

listed by the manufacturer. If your

vehicle does not have one, contact

a CITROËN dealer or a qualified

workshop to obtain the correct jack for

your vehicle.

Depending on version, the spare wheel and

tools are stowed in the boot under the floor.

Tools provided

The following tools are installed in a carrier,

located in the centre of the spare wheel:

1. Wheelbrace

2. Jack with handle

3. Removable towing eye.

F

Remove the boot carpet.

Remove the tool carrier.

Slacken the central wheel retaining bolt.

Remove the wheel.

Tyre pressures

These are indicated on the label affixed to the

middle pillar of the left door, driver's side.

Refer to the "Identification markings" section.

Refer to the "Towing the vehicle" section.

8

159

In the event of a breakdown

Removing a wheel

F

Remove the label from the middle of the

spare wheel (indicating that a wheel needs

repair), and fix it inside the vehicle, where

the driver can see it.

Remove the wheel trim using the end of the

wheelbrace.

F

Position the foot of the jack 2 on the ground

and ensure that it is directly below one

of the jacking points A or B located on

the underbody, closest to the wheel to be

changed.

F

Extend the jack 2 until its head is in contact

with the jacking point A or B used. The

contact area A or B on the vehicle used

must engage correctly with the middle of

the head of the jack.

F

Slacken the wheel bolts using the

wheelbrace 1.

Ensure that the jack is stable. If the ground is slippery or loose, the jack may slip or drop -

Risk of injury!

Ensure that the jack is positioned only at one of the jacking points A or B under the vehicle,

making sure that the vehicle's contact area is centred on the head of the jack. Otherwise

there is a risk of damage to the vehicle and/or of the jack dropping - Risk of injury !

160

In the event of a breakdown -> Spare wheel for Your Citroen C1 4 Door Second Generation (2014-2022)

Related Topics

In the event of a breakdown

Popular Owner Manuals

Latest Owner Manuals