ANTIꢀINTRUSION ALARM
Operating the alarm
First make sure all the doors are closed.
The alarm is armed by pressing button A on the remote
control.
With the alarm armed, the protections are active after
5 seconds (perimeter) and 45 seconds (volumetric).
When the alarm is armed (on standby), any intrusion
will trigger the siren for 30 seconds, accompanied by
the direction indicators lighting up.
The alarm then goes back on standby, but the triggerꢀ
ing remains memorised and is signalled by the rapid
flashing of the warning lamp on control 1 after you have
deactivated the alarm with a press on the unlocking
button B. The flashing stops when you switch on the
ignition.
Deactivating the volumetric detection
You can operate the alarm with perimeter protection
only, by deactivating the volumetric protection (if for
example you wish to leave an animal in the vehicle).
For this, switch off the ignition then immediately press
button 1 for at least one second.
The warning lamp on button 1 should come permaꢀ
nently on. It will start to flash when the alarm is armed.
Arm the alarm by locking your vehicle with the remote
control.
Automatic activation
(according to destination)
The alarm is armed automatically, 2 minutes after the
last door, or the boot, has been closed.
The siren is also triggered if there is a cutting of the
electrical supply. To stop it, restore the electrical supply
then press on the unlocking button B
Note:
In order to prevent the alarm from triggering when you
open one of the doors or the boot, it is essential to press
the unlocking button B again on the remote control.
If you want to lock your vehicle without arming the
alarm, just lock with the key only.
If you lock your vehicle and a door, or the boot, is
still open, the central locking does not operate but
the alarm will arm itself after approx. 45 seconds.
Note: The siren is automatically deactivated (for example
for disconnecting the battery) as soon as the vehicle is
unlocked using the remote control.
24
English 